Collisions and relative energy loss

AI Thread Summary
The discussion focuses on a simulated lab experiment involving collisions between a projectile and a target particle of similar mass. The participant is tasked with calculating the largest and smallest relative energy losses from ten collisions, but struggles with determining the initial velocity due to the unknown radius of the chamber. They have a formula for the mass ratio and relative energy loss, which they attempt to connect using the post-collision speed and scattering angle. The participant speculates that energy may not be lost in elastic collisions but transformed into another form. They believe they have derived the relative energy loss formula correctly, which could simplify their calculations for part (a).
dbakg00
Messages
20
Reaction score
1

Homework Statement


I am working on a simulated lab in which we have a single particle projectile launched at a target particle (located at the center of the circular chamber) of similar weight. Once the collision takes place, I record the time it takes for the scattered projectile to travel the radius of the circular chamber AND the scattering angle of the projectile. The purpose is to calculate the mass, M, of the target. I am given the mass, m, of the projectile. Before the trials took place, I measured the crossing time that the projectile (before the collision) took to cross the radius of the chamber. I took this measurement several times and I used the average value. The projectile is launched at an unchanging constant speed each time.

(a) I am being asked to find the largest and smallest relative energy losses among the ten collisions I studied. I know that KE=\frac{1}{2}mv^{2} but I am not given the radius of the chamber, so I can't find the initial velocity of the projectile before the collision. Once the collision has taken place, I record the post-collision crossing time and the scattering angle of the projectile. My program then gives me a "V" and a ratio of "M/m" from the following formula:

\frac{M}{m}=\frac{1+V^{2}-2V*cos\theta_{p}}{1-V^{2}}

where V=\frac{v_{p}}{v_{0}}

v_{0} is the pre-collision speed of the particle, v_{p} is the post-collision speed, and \theta_{p} is the scattering angle.

(b) I am also being asked to express the relative energy loss \delta as a function of V. Here is the given formula for energy loss:

\delta=\frac{E_{0}-E_{p}}{E_{0}}

(c) The previous two questions consider energy loss. But we have assumed that the energy is conserved in the collision. Is energy actually lost, and if not, where does it go?


Homework Equations



KE=\frac{1}{2}mv^{2}

\frac{M}{m}=\frac{1+V^{2}-2V*cos\theta_{p}}{1-V^{2}}

\delta=\frac{E_{0}-E_{p}}{E_{0}}



The Attempt at a Solution



(a) I have no idea where to start on this part. I'm thinking that if I understood this part, the the question in part b might be easier...?

(b) I am not sure where to start on this part because I don't know the radius of the chamber so I can't calculate the the velocities directly. I am, however, given the V for each trial run when I enter the scattering angle and crossing time post collision. I'm guessing that there is a way to use this V to figure out the relative energy loss, however, I can't see it. Can someone give me a clue?

(c) I think that the energy is not lost because it is an elastic collision. If this is true, then the energy must be converted to some other type of energy??

Please help. I apologize for the long post but I felt it was necessary to describe the experiment in complete detail. Thanks
 
Physics news on Phys.org
I think I may have figured out the answer to question (b)

If \delta=\frac{E_{0}-E_{p}}{E_{0}}

and E_{o} = Initial Kinetic Energy, which = \frac{1}{2}*m*{v_{0}}^{2}

then \delta=\frac{E_{0}}{E_{0}}-\frac{E_{p}}{E_{0}} = 1-\frac{E_{p}}{E_{0}} = 1-\frac{v_{p}}{v_{0}} = 1-V

Is this right? If so then part (a) should become pretty easy to calculate. Please let me know if you see any errors. Thanks
 
Kindly see the attached pdf. My attempt to solve it, is in it. I'm wondering if my solution is right. My idea is this: At any point of time, the ball may be assumed to be at an incline which is at an angle of θ(kindly see both the pics in the pdf file). The value of θ will continuously change and so will the value of friction. I'm not able to figure out, why my solution is wrong, if it is wrong .
TL;DR Summary: I came across this question from a Sri Lankan A-level textbook. Question - An ice cube with a length of 10 cm is immersed in water at 0 °C. An observer observes the ice cube from the water, and it seems to be 7.75 cm long. If the refractive index of water is 4/3, find the height of the ice cube immersed in the water. I could not understand how the apparent height of the ice cube in the water depends on the height of the ice cube immersed in the water. Does anyone have an...
Back
Top