Can Digital Encoder Make a Difference in Transmitting Low Frequency Signals?

  • Thread starter Thread starter Idea04
  • Start date Start date
  • Tags Tags
    Digital
AI Thread Summary
Digital encoders can potentially enhance the transmission of low-frequency signals, particularly in the VLF range (1Hz-90KHz), which is crucial for applications like submarine communication and underground data transfer. However, significant challenges remain, including the need for large antennas due to the long wavelengths and high power requirements to penetrate dense materials like rock or water. The data rates for these transmissions are typically low, necessitating advanced signal processing to manage background noise and ensure message integrity. While low-power electronic transceiver chips for these frequencies are scarce, RF carriers can be used for low data rate information transmission, provided they comply with FCC regulations. Overall, the feasibility of effective low-frequency digital signal transmission hinges on addressing these technical limitations.
Idea04
Messages
194
Reaction score
1
is there electronic transceiver chips that can transmit very low frequencies (1Hz-90KHz) for digital signals of low power, and small antenna chips for that frequency. from what I was reseaching I could find anything under a couple of MHz. But does using a digital encoder make a difference.
 
Engineering news on Phys.org
Very Low frequency VLF is used to transmitto submarinesand underground in eg. mines.
The problem is that you need very large antenaes - since the wavelength is so long.
You also need a lot of power to penetrate a large amount of rock or water in practical systems and the data rate is very low.
Onthe plus side, the frequency is low enough that you detect the waves directly and can do the mixing in software.

Generally you do use a lot of signal processing because there is a lot of background noise and thesesignals generally have important messages you don't want to get wrong!
 
Idea04 said:
is there electronic transceiver chips that can transmit very low frequencies (1Hz-90KHz) for digital signals of low power, and small antenna chips for that frequency. from what I was reseaching I could find anything under a couple of MHz. But does using a digital encoder make a difference.

As mgb says, if you are asking about using VLF carriers, then no, everything has to be physically large. Antennas are typically on the order of a quarter to a half wavelength of the EM radiation carrier in the air.

But if you are asking about transmitting low data rate information, you can do that with an RF carrier (as long as you meet the FCC regulations about RF transmissions in various bands, etc.).

Are you asking about VLF carrier transmissions, or low datarate RF transmission? BTW, the government would likely get very, very unhappy if you started stepping on submarine communications...
 
While I was rolling out a shielded cable, a though came to my mind - what happens to the current flow in the cable if there came a short between the wire and the shield in both ends of the cable? For simplicity, lets assume a 1-wire copper wire wrapped in an aluminum shield. The wire and the shield has the same cross section area. There are insulating material between them, and in both ends there is a short between them. My first thought, the total resistance of the cable would be reduced...
Hey guys. I have a question related to electricity and alternating current. Say an alien fictional society developed electricity, and settled on a standard like 73V AC current at 46 Hz. How would appliances be designed, and what impact would the lower frequency and voltage have on transformers, wiring, TVs, computers, LEDs, motors, and heating, assuming the laws of physics and technology are the same as on Earth?
Hi all I have some confusion about piezoelectrical sensors combination. If i have three acoustic piezoelectrical sensors (with same receive sensitivity in dB ref V/1uPa) placed at specific distance, these sensors receive acoustic signal from a sound source placed at far field distance (Plane Wave) and from broadside. I receive output of these sensors through individual preamplifiers, add them through hardware like summer circuit adder or in software after digitization and in this way got an...
Back
Top