Are Electric Superchargers Worth the Energy Storage Concerns?

  • Thread starter Thread starter Ryuk1990
  • Start date Start date
  • Tags Tags
    Electric
AI Thread Summary
Electric superchargers face significant challenges primarily due to energy storage limitations and the insufficient voltage of typical automotive batteries. The required power to compress air effectively for engine operation is substantial, making electric superchargers less viable compared to traditional mechanical systems like belt drives or turbochargers. While some manufacturers like Audi and Volvo are experimenting with electric supercharging technology, its practical application remains limited to short bursts of low boost. The most promising use for electric superchargers may be to assist in quickly spooling larger turbos. Overall, the consensus suggests that electric superchargers are not currently a practical solution for most automotive applications.
Ryuk1990
Messages
157
Reaction score
0
Does anyone here have any experience with electric superchargers? From the limited information I've read on the Internet, it seems energy storage is the biggest issue with them. For one, the average automotive vehicle tends to have a battery with too low of a voltage. Also, the motors that provide enough compression are too heavy/big.
 
Engineering news on Phys.org
The limiting factor goes back to power requirements- a lot of power is required to compress air at the pressure and flow rate required to run an engine. Paired with the fact that an electric supercharger requires its own energy storage and motor to drive the compressor, it's really a losing proposition compared to mechanically coupling to the engine either through belt drive or exhaust turbine drive (as in a turbocharger).
 
Last edited:
Audi has prototypes and some volvo trucks run a motor/generator instead of mechanical linking as in a turbo compound engine.
 
In short bursts, they can function at low boost levels. Probably their best use though would be to quickly spool up a larger turbo. Of course, electric-assist turbos do the same thing. :biggrin:
 
densifier

I am working on a fuel/O2 gas powered turbo system. Any thoughts?
 
I'm thinking that has nothing to do with this thread's topic...
 
How did you find PF?: Via Google search Hi, I have a vessel I 3D printed to investigate single bubble rise. The vessel has a 4 mm gap separated by acrylic panels. This is essentially my viewing chamber where I can record the bubble motion. The vessel is open to atmosphere. The bubble generation mechanism is composed of a syringe pump and glass capillary tube (Internal Diameter of 0.45 mm). I connect a 1/4” air line hose from the syringe to the capillary The bubble is formed at the tip...
Thread 'Physics of Stretch: What pressure does a band apply on a cylinder?'
Scenario 1 (figure 1) A continuous loop of elastic material is stretched around two metal bars. The top bar is attached to a load cell that reads force. The lower bar can be moved downwards to stretch the elastic material. The lower bar is moved downwards until the two bars are 1190mm apart, stretching the elastic material. The bars are 5mm thick, so the total internal loop length is 1200mm (1190mm + 5mm + 5mm). At this level of stretch, the load cell reads 45N tensile force. Key numbers...
I'd like to create a thread with links to 3-D Printer resources, including printers and software package suggestions. My motivations are selfish, as I have a 3-D printed project that I'm working on, and I'd like to buy a simple printer and use low cost software to make the first prototype. There are some previous threads about 3-D printing like this: https://www.physicsforums.com/threads/are-3d-printers-easy-to-use-yet.917489/ but none that address the overall topic (unless I've missed...
Back
Top