Find Voltage in the following circuit

  • Topic: Engineering 
  • Thread starter naivy
  • Start date
  • Tags Tags
    Circuit Voltage
3 replies · 2K views · last reply
naivy
Messages
40
Reaction score
0

Homework Statement



Circuit schematic with a dependent voltage source 6kIx at the top, two 4 kΩ resistors, a 16 V independent source, a 4 kΩ resistor labeled Ix, and output terminals marked Vo.


Homework Equations



nodal analysis, kvl, kcl, loop analysis?

The Attempt at a Solution



Can someone please tell me if my nodal equations look right?
Did I redraw the circuit properly?
Mainly I'm confused about how to treat that dependent current source at the top.

Handwritten circuit redraw with nodes V1, V2, V3 and ground, including a 6kIx dependent source, 16 V source, 4 kΩ resistors, beside handwritten nodal equations for V2 = 16 V, V3 and V1.
 
The source at the top looks like a voltage source, not a current source.
 
But the initial problem has a current running across the top, which led me to think that it's a current source. Are you sure it's a voltage source? If so, I have absolutely no idea how the nodal equations will work...
 
naivy said:
But the initial problem has a current running across the top, which led me to think that it's a current source. Are you sure it's a voltage source? If so, I have absolutely no idea how the nodal equations will work...

I see the classic diamond shape of a controlled source and within it + and - designations for polarity. To me that says "voltage source". If it were a current source I'd expect to see an arrow inside. To be on the safe side check with your reference materials for your course, which will likely follow a common standard.

This looks like a case where KVL loop equations will be a straightforward way to go. If your heart is set on nodal analysis, consider that a judicious choice of supernode will help :wink: