Fix Circuit Board: No Expertise Needed

  • Thread starter Thread starter 120rob
  • Start date Start date
  • Tags Tags
    Board Circuit
AI Thread Summary
The discussion focuses on repairing hair clippers that have a blown resistor after possibly getting wet. The clippers operate at 120v AC and emitted a toxic smell when they failed. Participants emphasize that the blown resistor might not be the root cause of the issue, as it could have failed to protect other components. They discuss the importance of identifying the resistor's full color code for proper replacement and suggest checking local stores for compatible parts. Overall, the conversation provides guidance on troubleshooting and repairing the clippers without needing extensive expertise.
120rob
Messages
2
Reaction score
0
(incase you are wondering I am not educated but have small mechanical know how) but I don't fully know how circuits behave. I have these hair clippers that seemed to blow a resister. It is a grey tube with a green stipe on one end and a gold stripe on the other. It is difinitely fried. I must get my hair clippers working again (without the purchase of a whole new kit). So do you think you can help me!
 
Engineering news on Phys.org
Hi 120Rob
Please tell us more:
what voltage are the clippers run at?
did a nasty smell come from the clippers, hot and rich and toxic-smelling?
Please tell us how the clippers died, and perhaps we can tell you what may have gone wrong.

Good luck
 
Last edited:
On the back of the razor it says,
120v AC 60Hz 5W
And yes, rich toxic smell came from razor when it quit working. I think I might have gotten it wet on the inside of the clippers.
 
Couple of things: First, the blown resistor may or may not be the root cause problem. It's possible that it sacrificed itself to protect whatever the true problem source was. So, you may replace this and maybe not fix the problem.

There should be more stripes on the resistor. These may be not identifiable due to scorch marks. The first green means "2". the last gold bar means "+/- 10%" and is the tolerance for the accuracy of the resistor value. You need two more bars from the first green end which are the next value for resistor (e.g. another green would, with the first then mean 22) and the next bar is 'power of ten' (which makes it a 2.2 ohm, or 22, or 2.2Kohm, etc. resistor). You can find the color code list with a simple web search.

Then there is the power handling level of the resistor (e.g. 1/4 watt, 1/2 watt, etc.). Look in Radio Shack (what few parts remain) for something of similar physical size and read off the wattage level for guidance.
 
Hey guys. I have a question related to electricity and alternating current. Say an alien fictional society developed electricity, and settled on a standard like 73V AC current at 46 Hz. How would appliances be designed, and what impact would the lower frequency and voltage have on transformers, wiring, TVs, computers, LEDs, motors, and heating, assuming the laws of physics and technology are the same as on Earth?
While I was rolling out a shielded cable, a though came to my mind - what happens to the current flow in the cable if there came a short between the wire and the shield in both ends of the cable? For simplicity, lets assume a 1-wire copper wire wrapped in an aluminum shield. The wire and the shield has the same cross section area. There are insulating material between them, and in both ends there is a short between them. My first thought, the total resistance of the cable would be reduced...
I used to be an HVAC technician. One time I had a service call in which there was no power to the thermostat. The thermostat did not have power because the fuse in the air handler was blown. The fuse in the air handler was blown because there was a low voltage short. The rubber coating on one of the thermostat wires was chewed off by a rodent. The exposed metal in the thermostat wire was touching the metal cabinet of the air handler. This was a low voltage short. This low voltage...
Back
Top