Free falling spinning rectangle

AI Thread Summary
A rectangular piece of paper spins as it falls, taking longer to reach the ground compared to other shapes due to its orientation and air resistance dynamics. The spinning motion is influenced by initial fall conditions, air streams, and the paper's lack of symmetry. There is potential to generate electricity from a free-falling propeller, although practical implementation would require consideration of the energy needed to lift it initially. The discussion highlights the complexities of aerodynamics and energy generation in free fall scenarios. Overall, the feasibility of using a falling propeller for practical purposes remains a topic of interest.
kurious
Messages
633
Reaction score
0
A rectangular piece of paper spins rapidly about its longitudinal axis as it falls
through the air.It takes longer to reach the ground than other shapes of paper.Why is this given that it spends a lot of time edge on to the flow of air and so encounters less resistance from the air than a surface of constant horizontal orientation?
And could I generate enough electricity from a free falling propeller to do something useful with - even if it's only going to turn on a light so I can read a book as I parachute from a plane at 2 in the morning.
 
Engineering news on Phys.org
I don't know what you meant about air resistence and stuff,
but I figure that the spinning part depends on start conditions
of the fall, air streams, and lack of symmetry.

As for generating power from a falling propeller, of course
it could be done. But remember the saying (in reveres though ;) ):
what comes down must first go up. :biggrin:

Live long and prosper.
 
How did you find PF?: Via Google search Hi, I have a vessel I 3D printed to investigate single bubble rise. The vessel has a 4 mm gap separated by acrylic panels. This is essentially my viewing chamber where I can record the bubble motion. The vessel is open to atmosphere. The bubble generation mechanism is composed of a syringe pump and glass capillary tube (Internal Diameter of 0.45 mm). I connect a 1/4” air line hose from the syringe to the capillary The bubble is formed at the tip...
Thread 'Calculate minimum RPM to self-balance a CMG on two legs'
Here is a photo of a rough drawing of my apparatus that I have built many times and works. I would like to have a formula to give me the RPM necessary for the gyroscope to balance itself on the two legs (screws). I asked Claude to give me a formula and it gave me the following: Let me calculate the required RPM foreffective stabilization. I'll use the principles of gyroscopicprecession and the moment of inertia. First, let's calculate the keyparameters: 1. Moment of inertia of...
Thread 'Physics of Stretch: What pressure does a band apply on a cylinder?'
Scenario 1 (figure 1) A continuous loop of elastic material is stretched around two metal bars. The top bar is attached to a load cell that reads force. The lower bar can be moved downwards to stretch the elastic material. The lower bar is moved downwards until the two bars are 1190mm apart, stretching the elastic material. The bars are 5mm thick, so the total internal loop length is 1200mm (1190mm + 5mm + 5mm). At this level of stretch, the load cell reads 45N tensile force. Key numbers...
Back
Top