Getting Back Into Physics: Struggling to Understand Electromagnetism

AI Thread Summary
The discussion focuses on the challenges of understanding the wave equation in electromagnetism after a five-year break from physics studies. The wave equation's components, including amplitude, wave number, angular frequency, and phase angle, are explained, emphasizing their roles in describing wave behavior. The participant expresses a need to grasp these concepts quickly due to an upcoming exam and acknowledges the importance of visualizing the wave properties. They plan to seek additional resources, such as web applets, to aid their understanding. Overall, the conversation highlights the struggle to reconnect with complex physics concepts and the importance of visualization in learning.
disknoir
Messages
19
Reaction score
0
I have come back to studying physics after 5 years and I'm doing a course in electromagnetism.

I've come to the wave equation and I'm a little rusty.

For example, the general solution,

A(z,t) = Acos(2*pi*z/L - 2*pi*f*t + phi)

I know basically what the terms mean, but I'm unsure how they work together to form the wave, and can't seem to form an intuitive picture in my head.

My exam is in 3 weeks, do I need to figure this out quickly. I find it near impossible to move on if I don't understand something like this.
 
Physics news on Phys.org
In the last paragraph, it should be "so" not "do" :)
 
A is the amplitude of the wave. Basically meaning the maximum values that the wave can reach.

2*pi/L is the wave number, k, where L is the wavelength. This takes your position and tells you where you are on the wave

2*pi*f is the angular frequency, omega, where f is the frequency. This takes your time and tells you where you are on the wave.

Phi is the phase angle. This tells you if your wave has been shifted at all. A phase angle of 0, 2pi, 4pi, etc will give you constructive interference between waves and a phase angle of pi, 3pi/2, etc will give you destructive interference

Notice how the units of z and L cancel out, as do the units of f and t

I hope that these make sense. And note that I'm still studying in undergrad so these might not be all right or accurate to the degree you were hoping for
 
Hey, thanks for replying.

I understand what you said, and this is basically what it says in my textbook.

I'm going to go away and have a think about this while I'm at work tomorrow. I'll also try and find some kind of web applet to help me visualise it.

I'll post it on here if I find a good one.
 
TL;DR Summary: I came across this question from a Sri Lankan A-level textbook. Question - An ice cube with a length of 10 cm is immersed in water at 0 °C. An observer observes the ice cube from the water, and it seems to be 7.75 cm long. If the refractive index of water is 4/3, find the height of the ice cube immersed in the water. I could not understand how the apparent height of the ice cube in the water depends on the height of the ice cube immersed in the water. Does anyone have an...
Thread 'Variable mass system : water sprayed into a moving container'
Starting with the mass considerations #m(t)# is mass of water #M_{c}# mass of container and #M(t)# mass of total system $$M(t) = M_{C} + m(t)$$ $$\Rightarrow \frac{dM(t)}{dt} = \frac{dm(t)}{dt}$$ $$P_i = Mv + u \, dm$$ $$P_f = (M + dm)(v + dv)$$ $$\Delta P = M \, dv + (v - u) \, dm$$ $$F = \frac{dP}{dt} = M \frac{dv}{dt} + (v - u) \frac{dm}{dt}$$ $$F = u \frac{dm}{dt} = \rho A u^2$$ from conservation of momentum , the cannon recoils with the same force which it applies. $$\quad \frac{dm}{dt}...
Back
Top