Help reduce the severity of accidents

  • Thread starter Thread starter fa08ti
  • Start date Start date
AI Thread Summary
An engineering company has designed large plastic barrels filled with antifreeze to reduce the severity of car accidents by absorbing impact energy when vehicles crash into them. In a test, a 1200 kg car slowed from 20 m/s to 8.0 m/s after hitting the barrels, resulting in an average net force of -36,000 N. If the car were to hit the bridge supports instead, the impact would likely convert all kinetic energy into heat, causing more severe damage. Antifreeze is preferred over water because it can absorb more heat energy, preventing freezing in cold conditions and potentially reducing the overall damage from a collision. The discussion highlights the importance of energy absorption in mitigating accident severity.
fa08ti
Messages
32
Reaction score
0
To help reduce the severity of accidents, an engineering company designs large plastic barrels filled with antifreeze that can be placed in front of bridge supports. in a simple test, a 1200 kg car moving at 20 m/s (W) crashes into several barrels. the car slows down to 8.0 m/s (W) in 0.40 s.

i found the average net force to be -36000 N (W)

b: what would happen if the car hit the bridge supprts instead of the barrels.

c: why do they use antifreeze instead of water.

i'm confused but i think that for both b and c, it's about the car's ability to bounce back?
 
Physics news on Phys.org


If the author of the problem has a tacit assumption that the bridge supports cannot move at all and that the car would not have any ricocheting velocity (which would seem to need to be specified, since this can easily be assumed not to be an elastic collision), then all the kinetic energy of the car must get converted into heat, making the wreckage and the portion of the bridge struck a much hotter mess.
I would suspect that a given volume of antifreeze has the capacity to absorb more heat energy than the same amount of water. The more energy is absorbed by the liquid in the barrels, the lower the temperature of the car wreckage(?)
 


does that mean the net force would increase?
 


I was thinking the water would freeze when it gets cold outside and cause a lot more damage.
 


I'd say yes, it takes more force to push something to a stop than it does to push something down to 8.0 m/s if you get to assume that the time duration of 0.40 s is the same in both cases.
 
Kindly see the attached pdf. My attempt to solve it, is in it. I'm wondering if my solution is right. My idea is this: At any point of time, the ball may be assumed to be at an incline which is at an angle of θ(kindly see both the pics in the pdf file). The value of θ will continuously change and so will the value of friction. I'm not able to figure out, why my solution is wrong, if it is wrong .
Thread 'Voltmeter readings for this circuit with switches'
TL;DR Summary: I would like to know the voltmeter readings on the two resistors separately in the picture in the following cases , When one of the keys is closed When both of them are opened (Knowing that the battery has negligible internal resistance) My thoughts for the first case , one of them must be 12 volt while the other is 0 The second case we'll I think both voltmeter readings should be 12 volt since they are both parallel to the battery and they involve the key within what the...
Thread 'Correct statement about a reservoir with an outlet pipe'
The answer to this question is statements (ii) and (iv) are correct. (i) This is FALSE because the speed of water in the tap is greater than speed at the water surface (ii) I don't even understand this statement. What does the "seal" part have to do with water flowing out? Won't the water still flow out through the tap until the tank is empty whether the reservoir is sealed or not? (iii) In my opinion, this statement would be correct. Increasing the gravitational potential energy of the...
Back
Top