How are wind turbine blades made to face the wind?

AI Thread Summary
Wind turbine blades are designed to face the wind through various mechanisms, including wind direction sensors and powered alignment systems in large turbines. Smaller and older turbines often utilize a tail vane based on the weathercock principle to maintain alignment. Historical windmills sometimes employed auxiliary turbines to adjust the mill head when sails were misaligned, while others relied on manual adjustments. Additionally, some small wind pumps feature a spring-loaded tail that allows blades to turn sideways in high winds, preventing damage. Understanding these mechanisms is crucial for optimizing wind turbine efficiency and longevity.
skeptic2
Messages
1,776
Reaction score
60
By noting the direction of the wind, the taper of the blades and the direction of rotation, it is obvious the turbine blades are facing the wind. On the other hand if you blow on a pinwheel while holding it loosely, it turns so the blades are away from the direction of the wind. Does anyone know what mechanism is employed to keep the blades facing the wind?
 
Engineering news on Phys.org
Large power generating wind turbines have wind direction sensors and powered mechanisms to align the turbine blades .

Smaller and older turbines sometimes just have a tail vane . Basically using the weathercock principle .

The old windmills often had a small auxilliary wind turbine driven mechanism instead of a tailvane . The auxilliary turbine was arranged so that it was inactive when main mill sails were correctly aligned for the wind direction but which powered up and moved the mill head around when the sails were out of alignment .

Many old mills though were just aligned manually .
 
As Nidum wrote; A wind-vane on the head, generates an error signal, that controls a servo-motor to drive the windmill head into the wind.

For historical systems, google images; 'windmill fantail'

Tower mills had high fantails at the back, coupled through reduction gears or belts to a pinion running on a fixed azimuth bull gear.

Post mills were walked around when needed with a tail-pole or the rear steps. Some post mills had fantails on the tail-pole or the rear steps that turned a wheel on the ground to keep the mill facing into the wind.

Small wind pumps used on farms offset the horizontal turbine axis sideways from the vertical azimuth axis. The tail is spring loaded from the head so as the wind increases, the turbine blades gradually turn to be side on to the wind. That limits the top speed of the turbine and so prevents destruction in wind storms. When the tail mechanism fails due to lack of regular service, the turbine blades are thrown, until unbalance breaks the shaft, whereupon the damaged turbine wheel heads off across the farm.
 
Thread 'Where is my curb stop?'
My water meter is submerged under water for about 95% of the year. Today I took a photograph of the inside of my water meter box because today is one of the rare days that my water meter is not submerged in water. Here is the photograph that I took of my water meter with the cover on: Here is a photograph I took of my water meter with the cover off: I edited the photograph to draw a red circle around a knob on my water meter. Is that knob that I drew a red circle around my meter...
Hi all, i have some questions about the tesla turbine: is a tesla turbine more efficient than a steam engine or a stirling engine ? about the discs of the tesla turbine warping because of the high speed rotations; does running the engine on a lower speed solve that or will the discs warp anyway after time ? what is the difference in efficiency between the tesla turbine running at high speed and running it at a lower speed ( as fast as possible but low enough to not warp de discs) and: i...

Similar threads

Replies
9
Views
2K
Replies
18
Views
4K
Replies
13
Views
42K
Replies
6
Views
9K
Replies
30
Views
3K
Replies
24
Views
2K
Replies
10
Views
3K
Back
Top