How Do Sound and Light Interfere in Physics Problems?

AI Thread Summary
The discussion focuses on the interference of sound and light in various physics problems involving wave behavior. In the first scenario, the phase difference between two sound waves reaching an observer is calculated, with a path difference of 0.61m leading to a phase of 3.35 rad. For minimal sound, the frequency adjustment for destructive interference is explored, with an emphasis on understanding the conditions for this phenomenon. The second scenario involves finding points of destructive interference between two speakers at 800Hz, with calculations for wavelength and relative minima discussed. The final problems address wave superposition and light refraction, highlighting the need for clarity in visualizing wave interactions and bubble visibility in a medium.
dekoi
1.) Two speakers are on a wall 2m apart. A listerner stands 3.00m from wall in front of one of the speakers. An oscillator runs both speakers at 300Hz.

a.) What is the phase difference between two waves when they reach observer?

b.) What is the frequency closest to 300Hz to which the oscillator may be adjusted such that the observer hears minimal sound?

I began by finding the path difference between the two waves. One is assumed to be on the ground, so its path is 3.0 m long. The other is ~3.5 (sqrt(13)). For part (a) path difference is 0.61m. \Delta r = \frac{\phi}{2\pi}\lambda and \lambda = \frac{v}{f}, hence i solved for \phi, and it turned out to be 3.35 rad. Can anyone verify this, and most importantly explain why i even did this? Any explanation would be great.
Part B asks me for the frequency when there is minimal sound. Minimal sound occurs when there is destructive interference. So according to my notes i equated the angle to (2n+1)\pi. Is this correct? What should i solve for and why?

2.) Two speakers are driven in phase by a common oscillator at 800Hz and face each other at distance of 1.25m. Locate the points along a line joining the two speakers where relative minima of sound pressure amplitude would be expected.
Once again, I am solving for the points where there is destructive interference. I could solve for wavelength via \frac{v}{f}. Thus wavelength equals 2.33m. Then i used the equation d = \frac{(2n+1)\lambda}{2}. Is this correct? What do i solve for? Where do i go from there?

3.) Two sinusoidal waves combine in medium are described by:
y = 3sin\pi(x + 0.6t)[/tex]<br /> and<br /> y = 3sin\pi(x - 0.6t)[/tex]&lt;br /&gt; Determine max transverse poistion of an element in medium at 0.250 cm. &lt;br /&gt; Any beginning suggestions would be great. I suppose i could find the sum of the two waves (the superposition), but I am not sure where to go from there.&lt;br /&gt; &lt;br /&gt; 4.) A cube (n = 1.59) has a small air bubble inside. When a 1.90cm coin is placed over the bubble on the outside of cube, the bubble cannon be seen by looking down into the cube at any angle. However, when a 1.75cm coin is placed directly over it, the bubble can be seen by looking down into the cube. What is the range of the possible depths of the air bubble beneath the surface?&lt;br /&gt; I attempted to draw the diagram for this, but couldn&amp;#039;t get a clear understanding of the situation. If anyone could draw me a sample diagram, i would be very grateful.
 
Physics news on Phys.org
No one?

Please...
 
I'm unsure as to why no one can help me on this.
 
If anyone can offer any kind of help, it would be greatly appreciated.

You don't have to answer all the questions at once, but even an answer to one of them will help me greatly.

Thank you.
 
Thread 'Minimum mass of a block'
Here we know that if block B is going to move up or just be at the verge of moving up ##Mg \sin \theta ## will act downwards and maximum static friction will act downwards ## \mu Mg \cos \theta ## Now what im confused by is how will we know " how quickly" block B reaches its maximum static friction value without any numbers, the suggested solution says that when block A is at its maximum extension, then block B will start to move up but with a certain set of values couldn't block A reach...
TL;DR Summary: Find Electric field due to charges between 2 parallel infinite planes using Gauss law at any point Here's the diagram. We have a uniform p (rho) density of charges between 2 infinite planes in the cartesian coordinates system. I used a cube of thickness a that spans from z=-a/2 to z=a/2 as a Gaussian surface, each side of the cube has area A. I know that the field depends only on z since there is translational invariance in x and y directions because the planes are...
Thread 'Calculation of Tensile Forces in Piston-Type Water-Lifting Devices at Elevated Locations'
Figure 1 Overall Structure Diagram Figure 2: Top view of the piston when it is cylindrical A circular opening is created at a height of 5 meters above the water surface. Inside this opening is a sleeve-type piston with a cross-sectional area of 1 square meter. The piston is pulled to the right at a constant speed. The pulling force is(Figure 2): F = ρshg = 1000 × 1 × 5 × 10 = 50,000 N. Figure 3: Modifying the structure to incorporate a fixed internal piston When I modify the piston...
Back
Top