How Far Does the Fragment Land After a Mid-Air Explosion?

  • Thread starter Thread starter cb
  • Start date Start date
  • Tags Tags
    Trajectory
AI Thread Summary
The discussion revolves around calculating the distance a fragment from a mid-air explosion lands after a shell is shot at an initial velocity of 20 m/s at a 60-degree angle. After the explosion, one fragment falls vertically while the other continues horizontally. The conservation of energy is used to determine the velocity at the maximum height, which is found to be 22.36 m/s. To find the total distance traveled by the moving fragment, conservation of momentum is suggested to calculate its new horizontal velocity post-explosion. The problem can then be treated as a standard projectile motion scenario to determine the additional distance traveled by the fragment.
cb
Messages
8
Reaction score
0
I need some help with the problem.

A shell is shot with an initial velocity v0 of 20 m/s, at an angle of 60 degrees with the horizontal. At the top of the trajectory, the shell explodeds into two fragments of equal mass. One fragment, whose speed immediately after the explosion is zero, falls vertically. How far from the gun does the other fragment land, assuming that the terrain is level and the air drag is negligible


First, I labled three parts of the trajectory.

1. At the initial position

K= (1/2) m * v^2
U = 0

2. At the max height of the trajectory

K = (1/2) (m/2) * v^2 ----> Because the shell exploded in half
U = (m/2) * g * h

3. At the end of the the trajectory

K = 0
U = 0


Then using the conservation of energy from points 1 to 2 I found the velocity at point 2 to be 22.36 m/s.

Now I have to finish the problem and find the total distance traveled. Can someone check my work up to now and give me some advice on how to find the total distance.
 
Physics news on Phys.org
the kinetic energy does not equal 0 at the end of the trajectory unless you are willing to calculate the work done by the Earth in slowing the piece to rest. Consider the moment that it touches the earth, not the impact.
 
True, but now I still have to solve for the total distance traveled.

I was thinking about finding the height with the equation h= v0^2* sin^2(alpha) / (2*g). But since the mass is cut in half, will that make the equation invalid?

If that is true I can find the distance for the first half. But I'm not sure how I would find the distance for the second half.
 
Use conservation of momentum to find out the new velocity of the half of the shell still moving horizontally. Keep in mind you started out with some P=Mv (where v is the horizontal component of the velocity). Now you have P = mv1 + mv2, where m = M/2. P must be the same in both situations and you already know v1 is zero (at the instant of the explosion). Find v2.

So now you have the new velocity of the shell piece and, treating this now as a typical projectile motion problem, you should be able to find the additional distance traveled.
 
Kindly see the attached pdf. My attempt to solve it, is in it. I'm wondering if my solution is right. My idea is this: At any point of time, the ball may be assumed to be at an incline which is at an angle of θ(kindly see both the pics in the pdf file). The value of θ will continuously change and so will the value of friction. I'm not able to figure out, why my solution is wrong, if it is wrong .
Thread 'Voltmeter readings for this circuit with switches'
TL;DR Summary: I would like to know the voltmeter readings on the two resistors separately in the picture in the following cases , When one of the keys is closed When both of them are opened (Knowing that the battery has negligible internal resistance) My thoughts for the first case , one of them must be 12 volt while the other is 0 The second case we'll I think both voltmeter readings should be 12 volt since they are both parallel to the battery and they involve the key within what the...
Back
Top