How To Fing Angular and Natural Frequencies WITH ANSYS ?

AI Thread Summary
To find natural and angular frequencies using ANSYS for a simple beam, users should refer to specific procedures outlined in resources like the provided link. The discussion emphasizes the importance of understanding the fundamentals of beam dynamics to apply them in ANSYS effectively. A simple supported beam example, even with overhangs, can illustrate the concepts clearly. Participants express gratitude for shared insights and resources that enhance understanding. Overall, the conversation focuses on practical guidance for utilizing ANSYS in frequency analysis.
mcf22
Messages
2
Reaction score
0
How To Fing Angular and Natural Frequencies WITH ANSYS ??

Good Day every body,
I am student in Ruhr Universität Bochum and I would like to ask please about the procedure how to find Natural and angular frequencies for a simple beam to get the idea fro it and to solve my proble.
I will be really tankfull for any reply.
Flaih
 
Engineering news on Phys.org
Thank you it was really nice from u to reply.
 
Thread 'Turbocharging carbureted petrol 2 stroke engines'

Thread 'Turbocharging carbureted petrol 2 stroke engines'

Hi everyone, online I ve seen some images about 2 stroke carbureted turbo (motorcycle derivation engine). Now.. In the past in this forum some members spoke about turbocharging 2 stroke but not in sufficient detail. The intake and the exhaust are open at the same time and there are no valves like a 4 stroke. But if you search online you can find carbureted 2stroke turbo sled or the Am6 turbo. The question is: Is really possible turbocharge a 2 stroke carburated(NOT EFI)petrol engine and...
View full post »

Thread 'HP Required to move a robot 10meters at 1.5m/sec'

I need some assistance with calculating hp requirements for moving a load. - The 4000lb load is resting on ball bearing rails so friction is effectively zero and will be covered by my added power contingencies. Load: 4000lbs Distance to travel: 10 meters. Time to Travel: 7.5 seconds Need to accelerate the load from a stop to a nominal speed then decelerate coming to a stop. My power delivery method will be a gearmotor driving a gear rack. - I suspect the pinion gear to be about 3-4in in...
View full post »

Similar threads

Shaft - find natural frequency of horizontal shaft with bearings
Replies
4
Views
3K
How to find the natural frequency in ansys apdl
Replies
2
Views
4K
How Do You Calculate the Natural Angular Frequency of a Dual-Spring System?
Replies
5
Views
3K
Why am I not getting the correct natural frequency?
Replies
8
Views
2K
How can we find the missing equation for solving spatial collisions of bodies?
Replies
2
Views
1K
Where does natural frequency comes from?
Replies
3
Views
2K
Find Natural Frequency of Structure: Cube (Box) of Honeycomb Sandwich Panels
Replies
1
Views
8K
How Do Resonant MEMS Accelerometers Detect Changes in Acceleration?
Replies
1
Views
13K
Which Is Better for Analyzing Natural Frequency in Flywheel Systems: FEM or MBS?
Replies
6
Views
6K
Modes of vibration, natural frequency
Replies
11
Views
55K

Hot Threads

Recent Insights

Back
Top