How to Interface Electrim CCD Camera EDC-1000TE with MATLAB?

  • Thread starter Thread starter panther2005
  • Start date Start date
  • Tags Tags
    Camera Ccd
AI Thread Summary
To interface the EDC-1000TE CCD camera with MATLAB, a PC interface card is required to transfer data from the camera to a PC. Users are advised to consult the camera's manual for specific details on compatible interface cards. A participant mentioned having a PC card installed in an ISA slot but lacking the necessary drivers. They plan to attempt configuration with MATLAB despite this challenge. Successful integration will depend on obtaining the correct drivers and ensuring compatibility with MATLAB.
panther2005
Messages
2
Reaction score
0
hi,
I have ccd camera EDC-1000TE and i want how to interfcace with matlab
thanks a lot
sorry for my english
 
Engineering news on Phys.org
thanks berkeman for ur help, good link
i have a pc card in isa slot nd i haven't the driver, i w'll try to configure with matlab
thanks again
 
Very basic question. Consider a 3-terminal device with terminals say A,B,C. Kirchhoff Current Law (KCL) and Kirchhoff Voltage Law (KVL) establish two relationships between the 3 currents entering the terminals and the 3 terminal's voltage pairs respectively. So we have 2 equations in 6 unknowns. To proceed further we need two more (independent) equations in order to solve the circuit the 3-terminal device is connected to (basically one treats such a device as an unbalanced two-port...
suppose you have two capacitors with a 0.1 Farad value and 12 VDC rating. label these as A and B. label the terminals of each as 1 and 2. you also have a voltmeter with a 40 volt linear range for DC. you also have a 9 volt DC power supply fed by mains. you charge each capacitor to 9 volts with terminal 1 being - (negative) and terminal 2 being + (positive). you connect the voltmeter to terminal A2 and to terminal B1. does it read any voltage? can - of one capacitor discharge + of the...

Similar threads

Back
Top