IC Design: Draw Stick Diagram for D-Latch

AI Thread Summary
The discussion centers on creating a stick diagram for a D-latch, specifically involving two inverters and two transmission gates. A participant expresses difficulty in drawing the diagram and requests assistance. Another member suggests using a Google search for resources related to stick diagrams for D-latches, noting that there are many helpful results available. The conversation emphasizes the importance of visual representation in understanding circuit design. Participants are encouraged to explore online resources for guidance.
zadero
Messages
1
Reaction score
0
does anyone know how to draw stick diagram for this D-latch? i know that 2 inverters and 2 transmission gates can be joined, but i just can't get it. can anyone show me how?
 

Attachments

  • D-latch.JPG
    D-latch.JPG
    16.2 KB · Views: 491
Engineering news on Phys.org
zadero said:
does anyone know how to draw stick diagram for this D-latch? i know that 2 inverters and 2 transmission gates can be joined, but i just can't get it. can anyone show me how?

I did a simple google search on the words from your post, stick diagram for this D-latch, and got lots of good hits. Here is the hit list. Let us know what you come up with!

http://www.google.com/search?source...enUS301US302&q=stick+diagram+for+this+D-latch

.
 

Thread 'Query on Isentropic relationships (such as PV^gamma = constant)'

Hi all, I have a question. So from the derivation of the Isentropic process relationship PV^gamma = constant, there is a step dW = PdV, which can only be said for quasi-equilibrium (or reversible) processes. As such I believe PV^gamma = constant (and the family of equations) should not be applicable to just adiabatic processes? Ie, it should be applicable only for adiabatic + reversible = isentropic processes? However, I've seen couple of online notes/books, and...
View full post »

Thread 'Dry sump pump issue'

I have an engine that uses a dry sump oiling system. The oil collection pan has three AN fittings to use for scavenging. Two of the fittings are approximately on the same level, the third is about 1/2 to 3/4 inch higher than the other two. The system ran for years with no problem using a three stage pump (one pressure and two scavenge stages). The two scavenge stages were connected at times to any two of the three AN fittings on the tank. Recently I tried an upgrade to a four stage pump...
View full post »

Similar threads

Derivation of First Storey Shear Rigidity for a Rigid Frame
Replies
2
Views
1K
Programs Switching from Law to Integrated Circuit Design/Semiconductors at Low Cost?
Replies
25
Views
2K
What am I missing in this voltage regulator design?
Replies
4
Views
4K
How to calculate the stiffness of a spring wire cantilever beam?
Replies
4
Views
2K
How big circuits are implemented on small IC
Replies
3
Views
2K
Simple(?) parabolic dish design question
Replies
2
Views
3K
Converting RTL design of computer architecture into REAL Hardware
Replies
14
Views
3K
Calculate IC equalizer frequencies and gain
Replies
1
Views
1K
Can a Toroidal Core and Hall Effect Sensor Create Transparent Permanent Memory?
Replies
13
Views
2K
Electronics Designing a buck converter with feedback and a regulated output
Replies
4
Views
2K

Hot Threads

Recent Insights

Back
Top