Laplace Equation on semi-infinite plate

AI Thread Summary
A problem involving a thin semi-infinite conductive plate with a voltage applied at one end was discussed, where the goal was to find the voltage V(x) at a distance x from the end. The initial solution, V(x)=-90*x+1, did not satisfy the boundary conditions at infinity, while the correct solution, V(x)=V0*10^(-x/d), did. The discussion highlighted that electrostatic potential satisfies Laplace's equation in regions with zero charge density and Poisson's equation otherwise. The realization that the problem involves a conductor clarified why the correct solution does not satisfy Laplace's equation. The charge density as a function of x was also mentioned as epsilon_0*(ln10)^2*exp(-x/d).
ZombieCat
Messages
4
Reaction score
0
Hello all!

I just finished the following problem:

Consider a thin semi-infinite plate of negligible thickness made of an isotropic conductive material. A voltage V0=1V is applied at x=0 on the plate (across the short dimension). At a distance x=d=1cm from the end (x=0) V is measured to be .1V. Find the voltage V(x) at an arbitrary distance x from the end.

In my first attempt I got V(x)=-90*x+1, which is a solution to the Laplace equation in 1D, but does not match the boundary condition at infinity.

I tried the problem again and got V(x)=V0*10^(-x/d), which matches all boundary conditions and is the correct answer. My question is why doesn't this solution satisfy the Laplace equation? Does it have to? Why/why not?
 
Physics news on Phys.org
The electrostatic potential only satisfies Laplace's equation in regions where the charge density is zero. The rest of the time it satisfies Poisson's equation.
 
Oh dangit! Cause we're dealing with a conductor gotcha! So I guess the epsilon_0*(ln10)^2*exp(-x/d) would be the charge density as a function of x.

Thanks!

*Maybe I should rename myself "the phorgetful physicist"...
 
Thread 'Question about pressure of a liquid'
I am looking at pressure in liquids and I am testing my idea. The vertical tube is 100m, the contraption is filled with water. The vertical tube is very thin(maybe 1mm^2 cross section). The area of the base is ~100m^2. Will he top half be launched in the air if suddenly it cracked?- assuming its light enough. I want to test my idea that if I had a thin long ruber tube that I lifted up, then the pressure at "red lines" will be high and that the $force = pressure * area$ would be massive...
I feel it should be solvable we just need to find a perfect pattern, and there will be a general pattern since the forces acting are based on a single function, so..... you can't actually say it is unsolvable right? Cause imaging 3 bodies actually existed somwhere in this universe then nature isn't gonna wait till we predict it! And yea I have checked in many places that tiny changes cause large changes so it becomes chaos........ but still I just can't accept that it is impossible to solve...
Back
Top