Magnetic Field Produced by Power Line

AI Thread Summary
The discussion focuses on calculating the magnetic field produced by a high-voltage power line located 4.5 meters above ground, with the power line running north to south. The compass needle's 32-degree angle to the east indicates the influence of both the Earth's magnetic field and the power line's magnetic field. Using Ampere's Law, the magnetic field from the power line is determined to be approximately 3.1 x 10^-5 T, which is a reasonable value compared to the Earth's magnetic field of 5.0 x 10^-5 T. The current in the power line can then be calculated based on this magnetic field strength. The discussion emphasizes the importance of vector components and trigonometry in solving the problem.
GarthVader
Messages
3
Reaction score
0
1. You are standing directly under a high-voltage power line that is 4.5m above you, and a detailed map that you have indicates that the power line runs exactly north to south. Your compass needle makes an angle of 32 degrees to the east with respect to the power line's direction.

a)Knowing that the magnitude of the Earth's magnetic field is approximately 5.0*10^-5 T, determine the magnitude and direction of the magnetic field produced by the power line at ground level.
b)How much current is being carried by the power line?
c)Is the current flowing toward the north or toward the south?




2. B = μoI/2πr



3. The basic set up is where I'm stuck. I can answer questions B and C rather easily once I know A, but I'm am at a standstill on how to acquire the B field for the power line. Any help would be greatly appreciated!
 
Physics news on Phys.org
Well your compass aligns with the magnetic field, which is a vector. You know the Earth's magnetic field, and you should know which direction that points. The only other magnetic component is the field from the power line. We know the direction the current is moving, so you should know the direction of the magnetic field lines from the power line. Therefore, you know the final magnetic field vector, one of the components of that vector, and the direction of the other component. Trigonometry should give you the magnitude. And you are correct in using Ampere's Law for that.
 
So by using the law of signs, I would get:

(5x10^-5)/sin(32°) = B/sin(58°)

Solving for B I get 8x10^-5

Is this right? The magnitude of B seems high to me. Shouldn't it be smaller than the Earth's field?
 
Hang on, I had that mixed up. It should be more like:

(5x10^-5)/sin(58°) = B/sin(32°)

Which would make B = 3.1x10^-5 T

Much more reasonable.
 
TL;DR Summary: I came across this question from a Sri Lankan A-level textbook. Question - An ice cube with a length of 10 cm is immersed in water at 0 °C. An observer observes the ice cube from the water, and it seems to be 7.75 cm long. If the refractive index of water is 4/3, find the height of the ice cube immersed in the water. I could not understand how the apparent height of the ice cube in the water depends on the height of the ice cube immersed in the water. Does anyone have an...
Thread 'Variable mass system : water sprayed into a moving container'
Starting with the mass considerations #m(t)# is mass of water #M_{c}# mass of container and #M(t)# mass of total system $$M(t) = M_{C} + m(t)$$ $$\Rightarrow \frac{dM(t)}{dt} = \frac{dm(t)}{dt}$$ $$P_i = Mv + u \, dm$$ $$P_f = (M + dm)(v + dv)$$ $$\Delta P = M \, dv + (v - u) \, dm$$ $$F = \frac{dP}{dt} = M \frac{dv}{dt} + (v - u) \frac{dm}{dt}$$ $$F = u \frac{dm}{dt} = \rho A u^2$$ from conservation of momentum , the cannon recoils with the same force which it applies. $$\quad \frac{dm}{dt}...
Back
Top