Automotive Why Do Marine Diesel Engines Have Different Firing Orders?

  • Thread starter Thread starter babakN
  • Start date Start date
AI Thread Summary
Marine diesel engines have varying firing orders, such as counterclockwise (CCW) 1-5-3-6-4-2 and clockwise (CW) 1-4-2-6-3-5, primarily for balance and efficiency. The firing order can depend on the engine configuration, including whether it is a two-stroke or four-stroke engine, and whether it is inline or V-shaped. Straight-six engines typically achieve perfect balance with a firing order of 1-5-3-6-2-4, while medium-speed marine engines often use a different sequence. Additionally, when using matched pairs of counter-rotating engines, variations in components like camshafts and lubrication systems are necessary. Understanding these differences is crucial for optimizing performance and reliability in marine applications.
babakN
Messages
1
Reaction score
0
TL;DR Summary
Firing order, from CCW and CW
This is my question, the reason for the difference in the firing order What is for diesel engines? Example CCW 1,5,3,6,4,2 CW is a 1,42,6,3,5
 
Engineering news on Phys.org
babakN said:
TL;DR Summary: Firing order, from CCW and CW

This is my question, the reason for the difference in the firing order What is for diesel engines? Example CCW 1,5,3,6,4,2 CW is a 1,42,6,3,5
Balance? A little more information would be useful.
 
Two stroke, or four stroke?
Inline 6, or V6 ?
Numbered from the front or the rear?

https://en.wikipedia.org/wiki/Firing_order#Common_firing_orders
"Straight-six engines typically use a firing order of 1-5-3-6-2-4, which results in perfect primary and secondary balance. However, a firing order of 1-2-4-6-5-3 is common on medium-speed marine engines."

Where a matched pair of counter rotating engines is used, the cranks may be the same, but the camshafts, fuel injection pump drive, and the oil lubrication pump will be different. The optimum bearing lubrication points will also be different.
 
  • Informative
  • Like
Likes Lnewqban, DaveE and berkeman
How did you find PF?: Via Google search Hi, I have a vessel I 3D printed to investigate single bubble rise. The vessel has a 4 mm gap separated by acrylic panels. This is essentially my viewing chamber where I can record the bubble motion. The vessel is open to atmosphere. The bubble generation mechanism is composed of a syringe pump and glass capillary tube (Internal Diameter of 0.45 mm). I connect a 1/4” air line hose from the syringe to the capillary The bubble is formed at the tip...
Thread 'Physics of Stretch: What pressure does a band apply on a cylinder?'
Scenario 1 (figure 1) A continuous loop of elastic material is stretched around two metal bars. The top bar is attached to a load cell that reads force. The lower bar can be moved downwards to stretch the elastic material. The lower bar is moved downwards until the two bars are 1190mm apart, stretching the elastic material. The bars are 5mm thick, so the total internal loop length is 1200mm (1190mm + 5mm + 5mm). At this level of stretch, the load cell reads 45N tensile force. Key numbers...
I'd like to create a thread with links to 3-D Printer resources, including printers and software package suggestions. My motivations are selfish, as I have a 3-D printed project that I'm working on, and I'd like to buy a simple printer and use low cost software to make the first prototype. There are some previous threads about 3-D printing like this: https://www.physicsforums.com/threads/are-3d-printers-easy-to-use-yet.917489/ but none that address the overall topic (unless I've missed...
Back
Top