Mechanical Engineer Class Interview

AI Thread Summary
A sophomore is seeking to conduct an interview with a mechanical engineer to gain insights into the field. The request emphasizes urgency for a response. Participants in the discussion inquire about the specific area of mechanical engineering the student is interested in, such as petroleum, defense, or aerospace. This clarification could help connect the student with a relevant professional. Engaging with an engineer in the desired field can provide valuable career guidance.
Kevin.Reid414
Messages
1
Reaction score
0
Hello, I am a sophomore and I need to conduct an interview on an engineer in the field i
wish to enter into one day, so i was looking for a mechanical engineer, so if someone could get back to me as soon as possible that would be great, thanks for your time,

Kevin.Reid414
 
Engineering news on Phys.org
Kevin.Reid414 said:
Hello, I am a sophomore and I need to conduct an interview on an engineer in the field i
wish to enter into one day, so i was looking for a mechanical engineer, so if someone could get back to me as soon as possible that would be great, thanks for your time,

Kevin.Reid414

what field? petro? defense? aero?
 

Thread 'Race car suspension Class'

Posted June 2024 - 15 years after starting this class. I have learned a whole lot. To get to the short course on making your stock car, late model, hobby stock E-mod handle, look at the index below. Read all posts on Roll Center, Jacking effect and Why does car drive straight to the wall when I gas it? Also read You really have two race cars. This will cover 90% of problems you have. Simply put, the car pushes going in and is loose coming out. You do not have enuff downforce on the right...
View full post »
Thread 'Physics of Stretch: What pressure does a band apply on a cylinder?'

Thread 'Physics of Stretch: What pressure does a band apply on a cylinder?'

Scenario 1 (figure 1) A continuous loop of elastic material is stretched around two metal bars. The top bar is attached to a load cell that reads force. The lower bar can be moved downwards to stretch the elastic material. The lower bar is moved downwards until the two bars are 1190mm apart, stretching the elastic material. The bars are 5mm thick, so the total internal loop length is 1200mm (1190mm + 5mm + 5mm). At this level of stretch, the load cell reads 45N tensile force. Key numbers...
View full post »

Thread 'Cantilever help'

I'm trying to decide what size and type of galvanized steel I need for 2 cantilever extensions. The cantilever is 5 ft. The space between the two cantilever arms is a 17 ft Gap the center 7 ft of the 17 ft Gap we'll need to Bear approximately 17,000 lb spread evenly from the front of the cantilever to the back of the cantilever over 5 ft. I will put support beams across these cantilever arms to support the load evenly
View full post »

Similar threads

Mechanical Engineer Career. Short 3 question interview.
Replies
1
Views
1K
Can You Help Find a Mechanical Engineer for an Urgent Student Interview?
Replies
1
Views
1K
Need to interview a Mechanical Engineer
Replies
1
Views
2K
Math vs. FE Method: Comparing Mechanical Engineering Focus
Replies
2
Views
2K
Mechanical Engineering projects
Replies
2
Views
1K
Specified Torque Specs on Automotive Fasteners -- Required or just suggestions?
Replies
13
Views
4K
3D printers for mechanical engineering
Replies
1
Views
1K
Solar Heat Gain Factor table for southern latitudes
Replies
3
Views
1K
Professional Mechanical Engineer Interview
Replies
1
Views
2K
Insights for a Mechanical Engineering student
Replies
11
Views
2K

Hot Threads

Recent Insights

Back
Top