In circuits oscillating at a single frequency, additional frequencies can emerge primarily due to non-linear components like diodes, which generate harmonics. Capacitors and inductors can also create resonances, allowing multiple frequencies to coexist. The discussion highlights a specific circuit using a transformer with three secondary coils and diodes, pulsed by a square wave, which results in an amplitude-modulated waveform. The interaction between the coils and their capacitance leads to resonant behavior, potentially explaining the observed additional frequencies. Understanding these interactions is crucial for effectively managing circuit behavior and achieving desired outcomes.
#1
hobbs125
108
0
If a circuit is oscillated at one frequency what basic components (resistors, capacitors, inductors) or configurations of components can cause other frequencies to appear?
None of the above, in order for more frequencies to be generated (usually harmonics) you need some non-linear component in the circuit; such as a diode.
#3
hobbs125
108
0
Ok, can you explain how it happens? I've been trying to understand but I don't quite get it?
#4
skeptic2
1,776
60
What kinds of other frequencies are you seeing. Are they harmonics of the fundamental or are they unrelated to the fundamental.
Both capacitors and inductors may create additional resonances and cause oscillation on more than one frequency at the same time. I've accidentally done that.
#5
hobbs125
108
0
I think that may be what's happening. I've got a circuit which consists of a transformer with three secondary coils connected in series. The transformer is pulsed with a square wave. Each secondary coil has a capacitance in parallel which is the coils capacitance. The circuit is oscillated so the secondary coils are at resonance to limit current. Two of The coils have a diode between them which is forward biased during the on time.
The circuits purpose is to charge a capacitor to a high voltage while limiting current.
I'm actually getting an am waveform across the coils which leads me to believe the frequencies are close.
What I'm not understanding though is how it's occurring.
Hey guys. I have a question related to electricity and alternating current. Say an alien fictional society developed electricity, and settled on a standard like 73V AC current at 46 Hz. How would appliances be designed, and what impact would the lower frequency and voltage have on transformers, wiring, TVs, computers, LEDs, motors, and heating, assuming the laws of physics and technology are the same as on Earth?
While I was rolling out a shielded cable, a though came to my mind - what happens to the current flow in the cable if there came a short between the wire and the shield in both ends of the cable?
For simplicity, lets assume a 1-wire copper wire wrapped in an aluminum shield. The wire and the shield has the same cross section area. There are insulating material between them, and in both ends there is a short between them.
My first thought, the total resistance of the cable would be reduced...
I used to be an HVAC technician. One time I had a service call in which there was no power to the thermostat. The thermostat did not have power because the fuse in the air handler was blown. The fuse in the air handler was blown because there was a low voltage short. The rubber coating on one of the thermostat wires was chewed off by a rodent. The exposed metal in the thermostat wire was touching the metal cabinet of the air handler. This was a low voltage short. This low voltage...