Why Did My Financial Calculator Stop Working?

  • Thread starter Thread starter slipkorn17
  • Start date Start date
  • Tags Tags
    Broken Calculator
AI Thread Summary
A user experienced issues with their financial calculator, which flashed on and off, indicating a possible loose connection. Upon inspection, they discovered a disconnected black wire from the B- terminal and a red wire that seemed to need reattachment to the battery. Suggestions included using a heated screwdriver for emergency soldering and lemon juice as a flux alternative. The discussion also touched on a puzzling metal piece, speculated to be a solderless clip for the battery. Ultimately, the user successfully completed their finance final with a high score despite the calculator troubles.
slipkorn17
Messages
3
Reaction score
0
Hello all,

So I write a finance final tomorrow morning and my financial calculator decided to quit working on me. The screen would flash as it turned off and on rapidly, almost as if there was a loose connection. So I popped 'er open and here is what I found:

http://i.imgur.com/UdASBX1.jpg

It looks like the red wire needs to be attached to the other side of the battery, but when I hold it there, it does not turn on. It also doesn't look like anything was soldered on to that side of the battery before. I'm also confused by the weird metal piece.

Thanks in advance.
 
Engineering news on Phys.org
Nevermind, the black wire just came off of the B- terminal. It's pretty much toast now without a soldering iron.
 
try heating the tip of a screwdriver on your stove for an emergency soldering iron.
Try a little lemon juice for flux, but rinse well.

.
 
jim hardy said:
try heating the tip of a screwdriver on your stove for an emergency soldering iron.
Try a little lemon juice for flux, but rinse well.

And for really fine work, a finishing nail held in Vise-Grips works too. Neat tip about the juice; I never heard of that one before. Thanks.

Slipkorn, is that puzzling piece of metal actually attached to the top of the case, or just lying there? I ask because it sort of looks as if it might be a solderless clip to attach to the battery.
 
17 months later - I just went out and bought a decent one for $60. Used it for that final and never again. Maybe I'll use it in my last year starting next week. Thanks for responses, though.

Killed the final, by the way. Ended the course with a 90+.
 
While I was rolling out a shielded cable, a though came to my mind - what happens to the current flow in the cable if there came a short between the wire and the shield in both ends of the cable? For simplicity, lets assume a 1-wire copper wire wrapped in an aluminum shield. The wire and the shield has the same cross section area. There are insulating material between them, and in both ends there is a short between them. My first thought, the total resistance of the cable would be reduced...
Hi all I have some confusion about piezoelectrical sensors combination. If i have three acoustic piezoelectrical sensors (with same receive sensitivity in dB ref V/1uPa) placed at specific distance, these sensors receive acoustic signal from a sound source placed at far field distance (Plane Wave) and from broadside. I receive output of these sensors through individual preamplifiers, add them through hardware like summer circuit adder or in software after digitization and in this way got an...
I am not an electrical engineering student, but a lowly apprentice electrician. I learn both on the job and also take classes for my apprenticeship. I recently wired my first transformer and I understand that the neutral and ground are bonded together in the transformer or in the service. What I don't understand is, if the neutral is a current carrying conductor, which is then bonded to the ground conductor, why does current only flow back to its source and not on the ground path...

Similar threads

Back
Top