Natural response and step response

AI Thread Summary
In a circuit with a current source in parallel with an inductor, resistor, and capacitor, the behavior is not strictly classified as a natural or step response. A step response occurs when a sudden change, like a switch being flipped, introduces a new source to the circuit. Conversely, a natural response refers to the behavior of the circuit due to initial conditions, where energy stored in capacitors or inductors dissipates over time. If the current source has a step function, it will create a step response; otherwise, the circuit's behavior is simply a result of its configuration. Understanding these concepts is crucial for analyzing circuit dynamics effectively.
2slowtogofast
Messages
134
Reaction score
1
ok i need some clarification if you have a circuit where a current source is in parallel with an inductor a resistor and a capacitor is this considered a natural response or a step response. I guess i thought a step response is if a switch is switched and a source is added then it is a step response not if it was there the whole time.
 
Engineering news on Phys.org
Not sure what a "natural response" is... Perhaps it means the steady-state behavior since "step response" is pretty much what you describe: how the circuit behaves when a sudden change in voltage or current is applied.
 
2slowtogofast said:
ok i need some clarification if you have a circuit where a current source is in parallel with an inductor a resistor and a capacitor is this considered a natural response or a step response.
Neither. It's just considered a circuit.

If the current source contains a step then there will be a step response. If there are nonzero initial conditions then there will be a natural response.
 
natural response means the a capacitor/inductor is discharging such that after a long time, the voltage and currents approaches 0

step response is when a source will try to charge the inductors capacitors such that after a long time, the capacitors/inductors connected will be charged. if the capacitors/inductors have high initial voltage/current than what the source has to offer they can discharge until it reaches a steady charged state with a lower voltage/current. please correct me, this is how i understand step and natural response
 
Thread 'Weird near-field phenomenon I get in my EM simulation'
I recently made a basic simulation of wire antennas and I am not sure if the near field in my simulation is modeled correctly. One of the things that worry me is the fact that sometimes I see in my simulation "movements" in the near field that seems to be faster than the speed of wave propagation I defined (the speed of light in the simulation). Specifically I see "nodes" of low amplitude in the E field that are quickly "emitted" from the antenna and then slow down as they approach the far...
Hello dear reader, a brief introduction: Some 4 years ago someone started developing health related issues, apparently due to exposure to RF & ELF related frequencies and/or fields (Magnetic). This is currently becoming known as EHS. (Electromagnetic hypersensitivity is a claimed sensitivity to electromagnetic fields, to which adverse symptoms are attributed.) She experiences a deep burning sensation throughout her entire body, leaving her in pain and exhausted after a pulse has occurred...
Back
Top