Need help designing a one way diagram for a street lighting controller

  • Thread starter Thread starter milos630
  • Start date Start date
  • Tags Tags
    Lighting
AI Thread Summary
A user seeks assistance in converting a three-way diagram for a street lighting controller into a one-way diagram, expressing confusion over the task. They mention learning from the forum but are currently facing challenges at work. Suggestions include visiting other electrical forums for additional help. The user apologizes for their English proficiency. The discussion emphasizes the need for clarity in electrical diagram design.
milos630
Messages
1
Reaction score
0
Hi to everybody on this forum. I'm reading you all the time and learned a lot of stuff here. Now i have some problems in the work and i need help from someone with expirience .My boss give me a three way diagram from controler,and i need to draw the scheme in one way diagram.Please help me to resolve this, i need to do it but I m so confused.
Thanks.
Sorry for my bead english.
 

Attachments

Engineering news on Phys.org
Last edited by a moderator:

Thread 'Underwater piezoelectric sensor array receive sensitivity'

Hi all I have some confusion about piezoelectrical sensors combination. If i have three acoustic piezoelectrical sensors (with same receive sensitivity in dB ref V/1uPa) placed at specific distance, these sensors receive acoustic signal from a sound source placed at far field distance (Plane Wave) and from broadside. I receive output of these sensors through individual preamplifiers, add them through hardware like summer circuit adder or in software after digitization and in this way got an...
View full post »

Thread 'Following up on the recent thread about Earth Resistance measurements'

I have recently moved into a new (rather ancient) house and had a few trips of my Residual Current breaker. I dug out my old Socket tester which tell me the three pins are correct. But then the Red warning light tells me my socket(s) fail the loop test. I never had this before but my last house had an overhead supply with no Earth from the company. The tester said "get this checked" and the man said the (high but not ridiculous) earth resistance was acceptable. I stuck a new copper earth...
View full post »
Thread 'Beauty of old electrical and measuring things, etc.'

Thread 'Beauty of old electrical and measuring things, etc.'

Even as a kid, I saw beauty in old devices. That made me want to understand how they worked. I had lots of old things that I keep and now reviving. Old things need to work to see the beauty. Here's what I've done so far. Two views of the gadgets shelves and my small work space: Here's a close up look at the meters, gauges and other measuring things: This is what I think of as surface-mount electrical components and wiring. The components are very old and shows how...
View full post »

Similar threads

Schematic capture / wiring diagram software
Replies
18
Views
2K
Multiple signals controlling relay
Replies
7
Views
238
How can I design of a Corner Reflector antenna?
Replies
27
Views
23K
Feedback controller design for boost converter
Replies
17
Views
3K
Engineering Control System mass spring damper
Replies
0
Views
1K
What is the "observer" in PID control?
Replies
12
Views
3K
Dynamometer output readings for my moped
Replies
2
Views
1K
Switching between parallel and series connections (solar)
Replies
31
Views
4K
Help with waveform control: frequency, phase and amplitude
Replies
46
Views
5K
LED Light Tail Lights: Find a Way to Turn Off/On!
Replies
5
Views
2K

Hot Threads

Recent Insights

Back
Top