Residual electromagnet magnetism

AI Thread Summary
Residual magnetism in an electromagnet does exist but is typically minimal and considered an undesirable side effect. This residual magnetism can cause the magnet to retain small particles, such as iron dust, when it should release them. While it may slightly reduce the power needed to reactivate the magnet, this effect is negligible and does not equate to free energy. The energy from any residual magnetism cannot be harnessed for practical use, as it does not generate electricity without an external force. Overall, the potential for energy savings from residual magnetism is too small to be of practical benefit.
bobbobwhite
Messages
51
Reaction score
0
Have always wondered this so maybe I can get an answer here: when a large industrial electromagnet is switched off and the electricity-produced magnetism ceases, is there a small amount of residual magnetism in the uncharged electro-magnet? If so, does it dissipate according to a established formula? If it exists, it is essentially free energy at that point, so could it be used for an alternate and lesser purpose before it dissipates thus saving the energy needed to produce it for this alternate use?

I imagine the real question here is: if it exists, does it have any practical use before it dissipates? Or, if it exists, is it too small an amount to be of any alternate benefit?

Thanks for all informed answers.
 
Engineering news on Phys.org
Residual magnetism in an electromagnet is an undesirable side effect.
It may mean that the magnet will still hold small particles like iron dust when it should let go of everything.

I don't think you can call it free energy except that it may take slightly less power to magnetize the magnet next time. However, electromagnets usually get the same power every time they are turned on, so this slight advantage is not used.

Mostly it is a very small effect because very low carbon iron is used to make the electromagnet.
 
You can't get energy out of a static magnetic field, so even with a high-remanence core (that's a fancy term that means a residual magnetic field is left after the coil is de-energized) you can't get any "free energy". As with all permanent magnets, you could move it through a coil to generate electricity--this is, after all, how all generators work--but that energy isn't free; the energy ultimately comes from whatever it is you use to move the magnet, be it coal, nuclear, gasoline or you.
 
Thanks for the responses. In considering all forms of energy conservation, I sometimes ponder any possible way to save wasted energy no matter how small or inefficient the savings may be. One day I may think of one that is practical but not this time, I must assume.
 
Hey guys. I have a question related to electricity and alternating current. Say an alien fictional society developed electricity, and settled on a standard like 73V AC current at 46 Hz. How would appliances be designed, and what impact would the lower frequency and voltage have on transformers, wiring, TVs, computers, LEDs, motors, and heating, assuming the laws of physics and technology are the same as on Earth?
While I was rolling out a shielded cable, a though came to my mind - what happens to the current flow in the cable if there came a short between the wire and the shield in both ends of the cable? For simplicity, lets assume a 1-wire copper wire wrapped in an aluminum shield. The wire and the shield has the same cross section area. There are insulating material between them, and in both ends there is a short between them. My first thought, the total resistance of the cable would be reduced...
I used to be an HVAC technician. One time I had a service call in which there was no power to the thermostat. The thermostat did not have power because the fuse in the air handler was blown. The fuse in the air handler was blown because there was a low voltage short. The rubber coating on one of the thermostat wires was chewed off by a rodent. The exposed metal in the thermostat wire was touching the metal cabinet of the air handler. This was a low voltage short. This low voltage...
Back
Top