Reversible operation of fuel cell

AI Thread Summary
The discussion focuses on the reversible operation of fuel cells, explaining that this occurs when the external circuit's voltage matches the fuel cell's electromotive force (emf), resulting in negligible current output. It highlights that, under practical conditions, internal irreversibilities reduce the emf and electrical work produced while increasing heat loss. The analogy of two batteries in parallel illustrates that current flows only when there is a voltage difference, emphasizing that balanced voltages lead to no current flow. Understanding this concept is crucial for grasping the thermodynamics of fuel cells and their operational limits. The conversation underscores the importance of voltage balance in fuel cell functionality.
Est120
Messages
54
Reaction score
3
TL;DR Summary
fuel cell under the scope of chemical thermodynamics; conditions for reversible operation
Can someone explain me what does the underlined part of the following passage mean?

"The reversible operation of a fuel cell implies that the external circuit exactly balances its emf, with the result that its current output is negligible. In actual operation under reasonable load, internal irreversibilities inevitably reduce the emf of the cell and decrease its production of electrical work while increasing the amount of heat transfer to the surroundings."​

I know what a reversible (thermodynamically speaking) path means, but i my knowledge in electronic devices is limited.
 
Engineering news on Phys.org
Est120 said:
TL;DR Summary: fuel cell under the scope of chemical thermodynamics; conditions for reversible operation

I know what a reversible (thermodynamically speaking) path means, but i my knowledge in electronic devices is limited.
This is essentially the argument about quasi-static processes. In order to have appreciable current flow the internal processes will need finite currents and finite voltages and disequalibrium.
In what context does one worry about reversibility of a fuel cell?
 
I know nearly nothing about fuel cell thermodynamics. However, they operate like a battery. Through some mystical (to me) alchemy they generate a voltage potential by separating electrons from ions and send electrons out through an external circuit to return to balance the ions left behind in the cell. The voltage they can make is finite, of course, and determined by the chemistry.

So imagine a circuit with two batteries connected in parallel (+ to +, - to - terminals). Current will flow from one to (through) the other if it's voltage is greater, it will flow the other direction if it's voltage is lower. So, they are describing a situation where the voltage from the fuel cell is exactly the same (balanced) with the voltage imposed from an external circuit. In this case no current will flow. Current always flows from a higher potential to a lower potential. No voltage difference means no current flow.
 
Hi all I have some confusion about piezoelectrical sensors combination. If i have three acoustic piezoelectrical sensors (with same receive sensitivity in dB ref V/1uPa) placed at specific distance, these sensors receive acoustic signal from a sound source placed at far field distance (Plane Wave) and from broadside. I receive output of these sensors through individual preamplifiers, add them through hardware like summer circuit adder or in software after digitization and in this way got an...
I have recently moved into a new (rather ancient) house and had a few trips of my Residual Current breaker. I dug out my old Socket tester which tell me the three pins are correct. But then the Red warning light tells me my socket(s) fail the loop test. I never had this before but my last house had an overhead supply with no Earth from the company. The tester said "get this checked" and the man said the (high but not ridiculous) earth resistance was acceptable. I stuck a new copper earth...
I am not an electrical engineering student, but a lowly apprentice electrician. I learn both on the job and also take classes for my apprenticeship. I recently wired my first transformer and I understand that the neutral and ground are bonded together in the transformer or in the service. What I don't understand is, if the neutral is a current carrying conductor, which is then bonded to the ground conductor, why does current only flow back to its source and not on the ground path...
Back
Top