Solar panel charging a 12volt battery

AI Thread Summary
Connecting a solar panel directly to a 12-volt battery can lead to variable current flow, which may harm the battery's lifespan due to high current levels. Using a switching regulator or charge controller between the solar panel and the battery allows for a controlled current flow, enhancing battery longevity and efficiency. Charging speed is influenced by the solar panel's output, which fluctuates based on environmental conditions. Maximizing the current to match the panel's output may speed up charging but risks damaging the battery without proper regulation. Therefore, a charge controller is essential for optimal power transfer and battery health.
zafranax
Messages
15
Reaction score
0
what will be the difference if the solar panel will be directly connected to the 12 volt battery or the solar panel is connected to a switching regulator before connected to the battery..which is faster to charge?..and what will be the difference in terms of power transfer?
 
Engineering news on Phys.org
we should not charge the batteries with the high current. now it depends what amount of the current your solar panel is providing. if we will connect the batteries directly to the panel the max current generated by the panel (which is variable throughout the day depending on the weather conditions, shadowing effects etc) will flow through batteries. so we should use a charge controller in between the panel and batteries for controlled amount of current flow in battery. and it is essential for battery life.
 
what if we will maximize the current that will charge the battery which is equal to the maximum current that the solar panel will produce in order to charge the battery faster..
 
Hi all I have some confusion about piezoelectrical sensors combination. If i have three acoustic piezoelectrical sensors (with same receive sensitivity in dB ref V/1uPa) placed at specific distance, these sensors receive acoustic signal from a sound source placed at far field distance (Plane Wave) and from broadside. I receive output of these sensors through individual preamplifiers, add them through hardware like summer circuit adder or in software after digitization and in this way got an...
While I was rolling out a shielded cable, a though came to my mind - what happens to the current flow in the cable if there came a short between the wire and the shield in both ends of the cable? For simplicity, lets assume a 1-wire copper wire wrapped in an aluminum shield. The wire and the shield has the same cross section area. There are insulating material between them, and in both ends there is a short between them. My first thought, the total resistance of the cable would be reduced...
I am not an electrical engineering student, but a lowly apprentice electrician. I learn both on the job and also take classes for my apprenticeship. I recently wired my first transformer and I understand that the neutral and ground are bonded together in the transformer or in the service. What I don't understand is, if the neutral is a current carrying conductor, which is then bonded to the ground conductor, why does current only flow back to its source and not on the ground path...
Back
Top