Solving Circuit Questions about 555 Timer & J-K Flip Flop

  • Thread starter Thread starter eku_girl83
  • Start date Start date
  • Tags Tags
    Circuit
AI Thread Summary
Understanding the 555 timer in monostable mode requires recognizing that if the reset signal is low (0), the output cannot be set to high (1) until the reset signal returns to high (1). For a J-K flip-flop, inputs can indeed cause changes in output during certain conditions, even without a clock transition, depending on the specific flip-flop design. Constructing a truth table for a flip-flop involves listing all possible input combinations and their corresponding outputs based on the flip-flop's behavior. Clarity on these concepts is essential for effective circuit design and troubleshooting. Further resources and examples can enhance comprehension of these digital components.
eku_girl83
Messages
89
Reaction score
0
I'm not completely understanding the concepts of the 555 timer and the J-K Flip Flop.
1) For a 555 timer in monostable mode, if the reset signal is at 0, how can I make the output a 1? Or is this even possible?
2) For a flip-flop switch with timing, can the inputs cause a change when a clock transition is not occurring?
3) How would I construct a truth table for a flip flop switch?

Any hints would be greatly appreciated!
Thanks
 
Engineering news on Phys.org
http://www.play-hookey.com/digital/jk_nand_flip-flop.html
 
Last edited by a moderator:
Thread 'Weird near-field phenomenon I get in my EM simulation'

Thread 'Weird near-field phenomenon I get in my EM simulation'

I recently made a basic simulation of wire antennas and I am not sure if the near field in my simulation is modeled correctly. One of the things that worry me is the fact that sometimes I see in my simulation "movements" in the near field that seems to be faster than the speed of wave propagation I defined (the speed of light in the simulation). Specifically I see "nodes" of low amplitude in the E field that are quickly "emitted" from the antenna and then slow down as they approach the far...
View full post »

Thread 'EMF (Electromagnetic Field) & EHS (Electromagnetic Hyper Sensitivity)'

Hello dear reader, a brief introduction: Some 4 years ago someone started developing health related issues, apparently due to exposure to RF & ELF related frequencies and/or fields (Magnetic). This is currently becoming known as EHS. (Electromagnetic hypersensitivity is a claimed sensitivity to electromagnetic fields, to which adverse symptoms are attributed.) She experiences a deep burning sensation throughout her entire body, leaving her in pain and exhausted after a pulse has occurred...
View full post »

Similar threads

Comp Sci Digital logic questions -- Designing counters with flip-flops
Replies
3
Views
1K
Abnormal low current from JK flip flop IC at toggle mode
Replies
34
Views
5K
Understanding D and JK Flip Flops
Replies
5
Views
5K
Powering a 555 Timer Circuit with 9VDC Battery
Replies
9
Views
2K
555 timer question & Bounceless Garage door opener.
Replies
9
Views
3K
Understanding Master-Slave Flip Flop
Replies
6
Views
4K
Latches and flip flops - how is stable state defined?
Replies
3
Views
9K
Build a Lightning Cloud with a 555 Timer | LED Flashing Help
Replies
16
Views
2K
Regarding jk flip flop Q' stability.
Replies
1
Views
3K
Creating a 555 Timer Circuit for Motor Control
Replies
19
Views
4K

Hot Threads

Recent Insights

Back
Top