- #1
Fantastic Fox
- 24
- 0
Has anyone got a link to manufacturers catalogues or websites (anything online?) where I can find standard pipe shaft sizes?
Standard Pipe Shaft Sizes: Catalogs & Websites
AI Thread Summary
The discussion centers on finding online resources for standard pipe shaft sizes, with participants seeking clarification on the terminology used. There is confusion regarding the use of "pipe" in relation to "shaft," as pipes are typically standardized while shafts vary by outer diameter. Participants encourage the original poster to specify their needs for better assistance. The conversation highlights the need for precise language when discussing engineering components. Overall, the thread emphasizes the importance of clarity in technical inquiries.
How did you find PF?: Via Google search
Hi,
I have a vessel I 3D printed to investigate single bubble rise. The vessel has a 4 mm gap separated by acrylic panels. This is essentially my viewing chamber where I can record the bubble motion. The vessel is open to atmosphere.
The bubble generation mechanism is composed of a syringe pump and glass capillary tube (Internal Diameter of 0.45 mm). I connect a 1/4” air line hose from the syringe to the capillary
The bubble is formed at the tip...
Scenario 1 (figure 1)
A continuous loop of elastic material is stretched around two metal bars. The top bar is attached to a load cell that reads force. The lower bar can be moved downwards to stretch the elastic material.
The lower bar is moved downwards until the two bars are 1190mm apart, stretching the elastic material. The bars are 5mm thick, so the total internal loop length is 1200mm (1190mm + 5mm + 5mm).
At this level of stretch, the load cell reads 45N tensile force.
Key numbers...
I'd like to create a thread with links to 3-D Printer resources, including printers and software package suggestions. My motivations are selfish, as I have a 3-D printed project that I'm working on, and I'd like to buy a simple printer and use low cost software to make the first prototype.
There are some previous threads about 3-D printing like this: https://www.physicsforums.com/threads/are-3d-printers-easy-to-use-yet.917489/
but none that address the overall topic (unless I've missed...
Similar threads
Automotive
Ratios, sprocket diameter, and acceleration
Hot Threads
-
Spring-loaded trigger stays in position after impact
- Started by oogaboogaengineering
- Replies: 15
- Mechanical Engineering
-
Automotive Brake Ventilation Air Duct Design
- Started by RS3DG
- Replies: 8
- Mechanical Engineering
-
Automotive Steering Force, Determining the Lever Arm
- Started by chevique
- Replies: 9
- Mechanical Engineering
Recent Insights
-
Insights Why Entangled Photon-Polarization Qubits Violate Bell’s Inequality
- Started by Greg Bernhardt
- Replies: 26
- Quantum Interpretations and Foundations
-
Insights Quantum Entanglement is a Kinematic Fact, not a Dynamical Effect
- Started by Greg Bernhardt
- Replies: 11
- Quantum Physics
-
Insights What Exactly is Dirac’s Delta Function? - Insight
- Started by Greg Bernhardt
- Replies: 3
- General Math
-
Insights Relativator (Circular Slide-Rule): Simulated with Desmos - Insight
- Started by Greg Bernhardt
- Replies: 1
- Special and General Relativity
-
Insights Fixing Things Which Can Go Wrong With Complex Numbers
- Started by PAllen
- Replies: 7
- General Math
-
Insights Fermat's Last Theorem
- Started by fresh_42
- Replies: 105
- General Math