Suggested waveform Amplifier for electromagnetoc coil testing?

AI Thread Summary
For testing electromagnetic coils with an RSR32 function generator, a waveform amplifier is essential. Users are seeking recommendations for affordable options that meet specific requirements, including frequency and current specifications. A suggested resource is a waveform amplifier from Accel Instruments, which may fit various testing needs. The discussion emphasizes the importance of matching the amplifier's capabilities to the user's experimental parameters. Finding the right amplifier is crucial for effective electromagnetic coil testing.
braydo25
Messages
1
Reaction score
0
Hi everyone, I am currently doing some experimentation with electromagnetic coils, I realize I will need a waveform amplifier for the testing using my rsr32 function generator. Could someone point me in the direction of a decently priced one?
 
Engineering news on Phys.org
What are your requirements? What frequency? How much current?

You can try this http://www.accelinstruments.com/Applications/TS200/Waveform-Amplifier.html" .
 
Last edited by a moderator:

Thread 'Underwater piezoelectric sensor array receive sensitivity'

Hi all I have some confusion about piezoelectrical sensors combination. If i have three acoustic piezoelectrical sensors (with same receive sensitivity in dB ref V/1uPa) placed at specific distance, these sensors receive acoustic signal from a sound source placed at far field distance (Plane Wave) and from broadside. I receive output of these sensors through individual preamplifiers, add them through hardware like summer circuit adder or in software after digitization and in this way got an...
View full post »

Thread 'Following up on the recent thread about Earth Resistance measurements'

I have recently moved into a new (rather ancient) house and had a few trips of my Residual Current breaker. I dug out my old Socket tester which tell me the three pins are correct. But then the Red warning light tells me my socket(s) fail the loop test. I never had this before but my last house had an overhead supply with no Earth from the company. The tester said "get this checked" and the man said the (high but not ridiculous) earth resistance was acceptable. I stuck a new copper earth...
View full post »

Thread 'Question about bonding ground and neutral'

I am not an electrical engineering student, but a lowly apprentice electrician. I learn both on the job and also take classes for my apprenticeship. I recently wired my first transformer and I understand that the neutral and ground are bonded together in the transformer or in the service. What I don't understand is, if the neutral is a current carrying conductor, which is then bonded to the ground conductor, why does current only flow back to its source and not on the ground path...
View full post »

Similar threads

Can a Square Wave Tachometer Drive be Powered by a Sine Waveform?
Replies
16
Views
3K
Cannot lock reference signal on lock-in amplifier
Replies
5
Views
2K
Why does a coil squash my function generator signal?
Replies
25
Views
6K
Help with waveform control: frequency, phase and amplitude
Replies
46
Views
5K
Bidirectional current switching with single type transistor
Replies
42
Views
5K
Creating a simulator for an electromagnetic mass driver
Replies
2
Views
1K
Heavy Amplifier Circuit Oscillation Happened
Replies
3
Views
2K
"Class-B" Audio Power Amp with "Current Pumping"
Replies
26
Views
3K
Calculation of induction heating setup power consumption
Replies
5
Views
2K
Why is impedance given as a simple Ohms unit when it's frequency dependent?
Replies
10
Views
2K

Hot Threads

Recent Insights

Back
Top