Thermal decomposition of calcium carbonate ?

AI Thread Summary
Heating calcium carbonate (CaCO3) to approximately 825°C causes it to decompose into calcium oxide (CaO) and carbon dioxide (CO2). Decomposition does not occur at temperatures below 825°C, as this process requires conditions where the Gibbs free energy is zero. If it were feasible to decompose CaCO3 at lower temperatures, industries such as cement and lime would likely adopt this method. The specified temperature of 825°C is based on standard conditions, where the partial pressure of CO2 is 1 atm.
makky2008
Messages
2
Reaction score
0
In general, we heat CaCO3 to temperature of approximately 825°C it decomposes into calcium oxide and liberates carbon dioxide gas:

CaCO3 →825°C→ CaO + CO2

Is it possible to heat the calcium carbonate at temperatures below 825 degrees Celsius, so the decomposition into calcium oxide.
 
Chemistry news on Phys.org
makky2008 said:
Is it possible to heat the calcium carbonate at temperatures below 825 degrees Celsius

Sure, you can heat it to any temperature you want :wink:

so the decomposition into calcium oxide.

Please translate into English, no idea what you were trying to ask.
 
If the OP is asking if calcium carbonate will decompose at a temp. below 825 C, the answer is no.

See this article:

http://en.wikipedia.org/wiki/Calcination

This type of decomposition occurs only at temperatures above which the Gibbs free energy is zero. Certainly, if this reaction could occur at lower temps., the cement and lime industry would be all over it.
 
This is slightly more complicated, 825 C is probably for a standard state, when the partial pressure of CO2 is expected to be 1 atm.
 
Thank you very much Mr.Borek and SteamKing.
 
I want to test a humidity sensor with one or more saturated salt solutions. The table salt that I have on hand contains one of two anticaking agents, calcium silicate or sodium aluminosilicate. Will the presence of either of these additives (or iodine for that matter) significantly affect the equilibrium humidity? I searched and all the how-to-do-it guides did not address this question. One research paper I found reported that at 1.5% w/w calcium silicate increased the deliquescent point by...
I was introduced to the Octet Rule recently and make me wonder, why does 8 valence electrons or a full p orbital always make an element inert? What is so special with a full p orbital? Like take Calcium for an example, its outer orbital is filled but its only the s orbital thats filled so its still reactive not so much as the Alkaline metals but still pretty reactive. Can someone explain it to me? Thanks!!
I'm trying to find a cheap DIY method to etch holes of various shapes through 0.3mm Aluminium sheet using 5-10% Sodium Hydroxide. The idea is to apply a resist to the Aluminium then selectively ablate it off using a diode laser cutter and then dissolve away the Aluminium using Sodium Hydroxide. By cheap I mean resists costing say £20 in small quantities. The Internet has suggested various resists to try including... Enamel paint (only survived seconds in the NaOH!) Acrylic paint (only...
Back
Top