- #1
roro36
- 27
- 1
We use induction furnaces to melt aluminium. I want to be able to read the temperature of the water in the pipe flowing in and out of the furnace. I am looking at a spot about 3m away but the induction from the furnace registers about 20mV on a scope which the thermocouples equate to 400V roughly.
If I move the thermocouples away, the water temp may have cooled too much and I still won't get an accurate reading.
Can anyone suggest a possible solution in either minimising the interference or using another sensor?
If I move the thermocouples away, the water temp may have cooled too much and I still won't get an accurate reading.
Can anyone suggest a possible solution in either minimising the interference or using another sensor?