Will an Airplane Maintain Uniform Circular Motion While Banking?

  • Thread starter Thread starter pb23me
  • Start date Start date
  • Tags Tags
    Motion Uniform
AI Thread Summary
An airplane can maintain uniform circular motion while banking, as the horizontal component of lift provides the necessary centripetal force. The relationship between lift and centripetal force is crucial; if the lift in the x-direction is insufficient, the plane will not sustain circular motion. Banking reduces vertical lift, necessitating an increase in angle of attack to compensate. A bank angle exceeding 30 degrees in a 737 series can lead to decreased lift and potential stalling. Ultimately, the balance of forces depends on the bank angle, speed, and radius of the turn to ensure safe flight dynamics.
pb23me
Messages
204
Reaction score
0

Homework Statement


General question:Decide wether an airplane will continue to fly in uniform circular motion while banking on a turn.


Homework Equations


m(v2/r)
\SigmaFx= Lsin\theta=m(v2/r)
\SigmaFy=Lcos\theta-mg=0

The Attempt at a Solution

my question is if the centripetal force m(v2/r)
is greater than the force of lift in th x direction Lsin\theta is that when it will no longer continue to fly in circular motion? also is there an amount of lift in the x direction that would be too much causing the plane to go in? If so then how do i know how much is the right amount to keep the plane in uniform circular motion?
 
Last edited:
Physics news on Phys.org
Yes it can fly in a circle until it exhausts all fuel.

By banking you know that the horizontal component provides the centripetal force to negotiate a circle. Yes, it reduces the vertical lift and so the airplane has to pitch up a bit so that the angle of attack is increased to compensate for the lost lift. Also since it flies sideways, drag is created which reduces the airspeed and so power has to be increased a bit. But a bank angle cannot exceed 30 degrees in a 737 series.
 
Ok but on a word problem asking if the force of lift is enough to keep the plane in curcular motion...how do i decide if it is enough?
 
would i set it equal to the equation for centripetal force m(v2/r)? and if it -force of lift- is smaller then its not enough?
 
pb23me said:
Ok but on a word problem asking if the force of lift is enough to keep the plane in curcular motion...how do i decide if it is enough?

It depends on what is radius of the circle needed and speed of the airplane.
Sharper turns are better done at low speeds because the centripetal force is lower. At low speeds, list is developed by extending flaps and slats. since for a give radius of turn, the centripetal force is much lower, less lift is stolen to provide centripetal force.

Also better experience for passengers.

V^2/r = L * sin(theta)

Initially a small bank angle won't decrease much the overall lift. The banking itself is caused by increasing lift on one wing and decreasing on the other. So upto a certain bank angle (say 15 deg), centripetal force can be provided. At high bank angles, overall lift starts decreasing faster and raising the nose may cause a stall.
 
pb23me said:
would i set it equal to the equation for centripetal force m(v2/r)? and if it -force of lift- is smaller then its not enough?

Assume bank angle is theta.
Assume lift force is L normal to the wings after banking

Balancing vertical forces of flight:

Lcos(theta) = mg

Balancing horizontal forces,

Lsine(theta) = mv^2/r

Now tan(theta) = v^2/rg

For a given theta and small r, v has to be small
 
Thread 'Variable mass system : water sprayed into a moving container'
Starting with the mass considerations #m(t)# is mass of water #M_{c}# mass of container and #M(t)# mass of total system $$M(t) = M_{C} + m(t)$$ $$\Rightarrow \frac{dM(t)}{dt} = \frac{dm(t)}{dt}$$ $$P_i = Mv + u \, dm$$ $$P_f = (M + dm)(v + dv)$$ $$\Delta P = M \, dv + (v - u) \, dm$$ $$F = \frac{dP}{dt} = M \frac{dv}{dt} + (v - u) \frac{dm}{dt}$$ $$F = u \frac{dm}{dt} = \rho A u^2$$ from conservation of momentum , the cannon recoils with the same force which it applies. $$\quad \frac{dm}{dt}...
TL;DR Summary: I came across this question from a Sri Lankan A-level textbook. Question - An ice cube with a length of 10 cm is immersed in water at 0 °C. An observer observes the ice cube from the water, and it seems to be 7.75 cm long. If the refractive index of water is 4/3, find the height of the ice cube immersed in the water. I could not understand how the apparent height of the ice cube in the water depends on the height of the ice cube immersed in the water. Does anyone have an...
Back
Top