Can US Tire Warmers Be Used in Australia Without a Transformer?

  • Thread starter Thread starter shippy__
  • Start date Start date
  • Tags Tags
    Tire
AI Thread Summary
Using US tire warmers in Australia without a transformer is not advisable unless the device explicitly states it can handle both voltages. Tire warmers designed for 120V will be damaged or pose a fire risk if connected directly to 240V power. A step-down transformer rated for 2000W is the recommended solution for safe operation. Users should always verify the voltage compatibility of their appliances before use. Proper precautions ensure both safety and functionality.
shippy__
Messages
5
Reaction score
0
Hi everyone, stumbled across this forum in my quest for answers regarding my tire warmers

Righto I purchased some pretty flash tire warmers for my 1198s ducati from the US I saved a heap. I bought them with the intentions of buying a step down transformer (240V to 120V 2000W), I have made some inquiries and among the inquiries some have mentioned I might not need a transformer as some appliances can plug straight into the wall with only the use of a plug adapter!

I wouldn't be asking this question if doubt wasn't cast into my mindTire warmers are basically a hot blanket with 3 temp settings, this set draws 1400w and are made for the USWhat do you recommend ?
 
Last edited:
Engineering news on Phys.org
shippy, Welcome to Physics Forums!

There are some devices that can operate on 240 Volts or 120 Volts. But unless your heater blanket is marked specifically with this capability, do not risk damage or fire.

Do not connect that 120 Volt device made for the U. S. to your 240 Volt wall power! If you do, expect maximum smoke!

Your plan to use the step-down transformer (240V to 120V 2000W) is the correct one.

Cheers,
Bobbywhy
 
thanks mate
 

Thread 'How might electronics be different if AC voltage was 72V at 45 Hz?'

Hey guys. I have a question related to electricity and alternating current. Say an alien fictional society developed electricity, and settled on a standard like 73V AC current at 46 Hz. How would appliances be designed, and what impact would the lower frequency and voltage have on transformers, wiring, TVs, computers, LEDs, motors, and heating, assuming the laws of physics and technology are the same as on Earth?
View full post »

Thread 'What happens if shielded cable has a short to the shield?'

While I was rolling out a shielded cable, a though came to my mind - what happens to the current flow in the cable if there came a short between the wire and the shield in both ends of the cable? For simplicity, lets assume a 1-wire copper wire wrapped in an aluminum shield. The wire and the shield has the same cross section area. There are insulating material between them, and in both ends there is a short between them. My first thought, the total resistance of the cable would be reduced...
View full post »

Thread 'Why does the amperage go real high if there is a low voltage short?'

I used to be an HVAC technician. One time I had a service call in which there was no power to the thermostat. The thermostat did not have power because the fuse in the air handler was blown. The fuse in the air handler was blown because there was a low voltage short. The rubber coating on one of the thermostat wires was chewed off by a rodent. The exposed metal in the thermostat wire was touching the metal cabinet of the air handler. This was a low voltage short. This low voltage...
View full post »

Similar threads

US 2-phase conversion to EU one phase
Replies
41
Views
18K
Python Perform an image deconvolution using FFTs and Python
Replies
1
Views
3K
Can you help me solve this differential equation using laplace transforms?
Replies
5
Views
2K
Chemically regenerating my auto's catalytic converter?
Replies
19
Views
7K
How Can the Philosophies of Great Physicists Guide Us Beyond the Standard Model?
Replies
6
Views
4K
Mathematica This Week's Finds in Mathematical Physics (Week 217)
Replies
2
Views
2K

Hot Threads

Recent Insights

Back
Top