Exploding Capacitor: Calculating Voltage for a 100uF 10V Capacitor

  • Thread starter Thread starter Momosaida
  • Start date Start date
  • Tags Tags
    Capacitors Voltage
AI Thread Summary
A 100uF 10V electrolytic capacitor can theoretically explode if reverse-biased, but practical outcomes may vary. Connecting a 9V battery backwards did not cause an explosion, raising questions about whether the connection was indeed reversed. The discussion highlights that while any voltage can potentially lead to failure, the actual results depend on various factors, including the capacitor's condition and the voltage applied. Participants caution against experimenting for safety reasons, emphasizing the potential for waste and disruption in educational settings. Overall, the thread underscores the risks associated with reverse biasing capacitors.
Momosaida
Messages
5
Reaction score
0
How many volts would i need to make a 100uF 10V capacitor explode if i plugged it in backwards?
 
Engineering news on Phys.org
Theoretically the moment you reverse bias the polarized cap, the cap will explode. You can try it out, wear goggles.
 
If it is electrolytic, which you didn't say, then practically any voltage will cause it to explode. As Corneo says it easy to try...and it's also a good way to make lecturers/teachers/lab technicians/fellow students rather cross with you - both for wasting caps and making them jump every few minutes :P
 
Yes the capacitor is electrolytic. But when I connected a 9V battery to it backwards, it didn't explode. Why?
 
Last edited:
Are you sure it was backwards?...I know it's obvious but some people, even degree level students, get that wrong. 9V should be plenty to do the job, unless it's a huuge capacitor it might be a bit harder. I can't say I have every studied the ins and outs of reversing caps! :)
 
I'm uncomfortable with this thread. Momosaida -- there are better things for you to be doing with your time instead of trying to blow up capacitors.

Thread locked.
 
Hi all I have some confusion about piezoelectrical sensors combination. If i have three acoustic piezoelectrical sensors (with same receive sensitivity in dB ref V/1uPa) placed at specific distance, these sensors receive acoustic signal from a sound source placed at far field distance (Plane Wave) and from broadside. I receive output of these sensors through individual preamplifiers, add them through hardware like summer circuit adder or in software after digitization and in this way got an...
I have recently moved into a new (rather ancient) house and had a few trips of my Residual Current breaker. I dug out my old Socket tester which tell me the three pins are correct. But then the Red warning light tells me my socket(s) fail the loop test. I never had this before but my last house had an overhead supply with no Earth from the company. The tester said "get this checked" and the man said the (high but not ridiculous) earth resistance was acceptable. I stuck a new copper earth...
I am not an electrical engineering student, but a lowly apprentice electrician. I learn both on the job and also take classes for my apprenticeship. I recently wired my first transformer and I understand that the neutral and ground are bonded together in the transformer or in the service. What I don't understand is, if the neutral is a current carrying conductor, which is then bonded to the ground conductor, why does current only flow back to its source and not on the ground path...
Back
Top