Want to build a home-made generator

  • Thread starter Thread starter jagman454
  • Start date Start date
  • Tags Tags
    Build Generator
AI Thread Summary
Building a homemade generator can be achieved by reversing the motion of an electric motor, effectively turning it into a generator. Using an automobile alternator is a viable option, but its efficiency in charging a 12V car battery depends on the RPM at which it spins. It is suggested that spinning the alternator at around 450 RPM, typical for engine idle speed, should yield a voltage output between 13 and 14.5 volts. Additionally, it's important to provide voltage to the field windings of the alternator to generate an output. Testing with an ammeter and voltmeter is recommended for precise measurements.
jagman454
Messages
2
Reaction score
0
First off thanks for the quick replys on my first post. Now, I'm looking to build a home-made generator, I've been told that I can just reverse the motion of a electric motor and *poof* it becomes a generator, is this true? And I was also considering just using a automobile alternator as my generator, But at what RPM would the alternator have to spin to give off efficient charge to charge a 12v car battery?
 
Engineering news on Phys.org
that is dependent on the strength of the magnets and how much flux is created by the alternator.
Unless you already have the details of the alternator, the best way is to just hook up an ammeter and volt meter and spin it yourself and take a few readings
 
From a backyard mechanic/racer perspective, I would assume that spinning your alternator at the basic idle speed of an engine (450+rpm) should provide an adequate charging output. That should be between 13 and 14.5 volts.
 
Danger said:
From a backyard mechanic/racer perspective, I would assume that spinning your alternator at the basic idle speed of an engine (450+rpm) should provide an adequate charging output. That should be between 13 and 14.5 volts.
... taking into account whatever gear ratio (if any) is applied by the belts and pulleys.
 
Also you need to provide voltage to the field windings before you can get an output. For most auto alternators.
 
Hi all I have some confusion about piezoelectrical sensors combination. If i have three acoustic piezoelectrical sensors (with same receive sensitivity in dB ref V/1uPa) placed at specific distance, these sensors receive acoustic signal from a sound source placed at far field distance (Plane Wave) and from broadside. I receive output of these sensors through individual preamplifiers, add them through hardware like summer circuit adder or in software after digitization and in this way got an...
I have recently moved into a new (rather ancient) house and had a few trips of my Residual Current breaker. I dug out my old Socket tester which tell me the three pins are correct. But then the Red warning light tells me my socket(s) fail the loop test. I never had this before but my last house had an overhead supply with no Earth from the company. The tester said "get this checked" and the man said the (high but not ridiculous) earth resistance was acceptable. I stuck a new copper earth...
Thread 'Beauty of old electrical and measuring things, etc.'
Even as a kid, I saw beauty in old devices. That made me want to understand how they worked. I had lots of old things that I keep and now reviving. Old things need to work to see the beauty. Here's what I've done so far. Two views of the gadgets shelves and my small work space: Here's a close up look at the meters, gauges and other measuring things: This is what I think of as surface-mount electrical components and wiring. The components are very old and shows how...
Back
Top