What Could Be Causing My Ride-On Mower to Fail to Start?

  • Thread starter Thread starter Snowy
  • Start date Start date
AI Thread Summary
The Countax ride-on mower fails to start after being turned off automatically when the user exited without shutting it down. There is no engine noise when turning the ignition key, suggesting an issue with the starter solenoid or ignition system. Possible causes include a faulty kill switch under the seat or an engaged blade switch that prevents the starter from turning. Users recommend checking for a reset option and ensuring that safety switches are not engaged. Troubleshooting these components may help resolve the starting issue.
Snowy
Messages
4
Reaction score
0
hi. i have a countax ride on mower. i accidently got off it without turning the engine off, so it cuts out automatically (like it should do), but now it won't start, there's absolutly no engine noise wen i turn the key in the ignition. i was wondering wot people think might have happnd n how i culd fix it? thanks
 
Engineering news on Phys.org
When you say "absolutely no engine noise" does that include the engine not even cranking? If it's not cranking, there must have been some sort of cut out done to the starter solenoid. I would think the safety would just kill the fuel flow to the engine, but perhaps more items get cut out.

Are you sure there's no kind of reset or something along those lines that you need to look at?
 
They usually disable the ignition. Are you sure you don't have the switch thrown that puts the blades in gear? Having this switch on will not allow the starter to turn.
 
Averagesupernova said:
They usually disable the ignition. Are you sure you don't have the switch thrown that puts the blades in gear? Having this switch on will not allow the starter to turn.
yeah its either that or the kill switch is faulty , the one under the seat..
 
its probably carberated so it kills the ignition instead... Like they said the switch under the seat is most likely faulty.
 
Last edited:
I have Mass A being pulled vertically. I have Mass B on an incline that is pulling Mass A. There is a 2:1 pulley between them. The math I'm using is: FA = MA / 2 = ? t-force MB * SIN(of the incline degree) = ? If MB is greater then FA, it pulls FA up as MB moves down the incline. BUT... If I reverse the 2:1 pulley. Then the math changes to... FA = MA * 2 = ? t-force MB * SIN(of the incline degree) = ? If FA is greater then MB, it pulls MB up the incline as FA moves down. It's confusing...
Hi. I noticed that all electronic devices in my household that also tell time eventually lag behind, except the ones that get synchronized by radio signal or internet. Most of them are battery-powered, except my alarm clock (which runs slow as well). Why does none of them run too fast? Deliberate design (why)? Wrong temperature for quartz crystal? Decreasing battery voltage? Or just a coincidence?
Back
Top