What is the Best Software for RF PCB Design and Simulation?

AI Thread Summary
Microwave Office is highly recommended for RF PCB design and simulation, though it is considered expensive. Sonnet offers a good alternative, especially with discounts available for university students and a free limited version for simple circuits. Cadsoft Eagle is another option, also free but with limitations, and may have university deals. Altium is suggested as a potential software to explore as well. Overall, various software options are available, catering to different budget constraints and needs.
chakr
Gold Member
Messages
34
Reaction score
2
Hi all, can anyone recommend a good software to help in design and simulation of PCB traces, matching circuits, and microstrip lines.
Thank you.
 
Engineering news on Phys.org
Microwave Office is one of the standard (and excellent) professional tools.
 
Thank you marcusl. I have contacted their sales representative. Its kinda pricey. Will see what my boss have to say abot it.
:)
 
Sonnet is quite good; and if you are at a university you get a very good discount.
There is also a free -but limited- version that is nevertheless useful for simple circuits.
 
hello chakr,

you can start with the free version of cadsoft eagle. its free. but limited. perhaps your university has also a deal with eagle.
have fun
 
this software: Altium， you can have a try.:wink:
 

Thread 'How might electronics be different if AC voltage was 72V at 45 Hz?'

Hey guys. I have a question related to electricity and alternating current. Say an alien fictional society developed electricity, and settled on a standard like 73V AC current at 46 Hz. How would appliances be designed, and what impact would the lower frequency and voltage have on transformers, wiring, TVs, computers, LEDs, motors, and heating, assuming the laws of physics and technology are the same as on Earth?
View full post »

Thread 'What happens if shielded cable has a short to the shield?'

While I was rolling out a shielded cable, a though came to my mind - what happens to the current flow in the cable if there came a short between the wire and the shield in both ends of the cable? For simplicity, lets assume a 1-wire copper wire wrapped in an aluminum shield. The wire and the shield has the same cross section area. There are insulating material between them, and in both ends there is a short between them. My first thought, the total resistance of the cable would be reduced...
View full post »

Thread 'Why does the amperage go real high if there is a low voltage short?'

I used to be an HVAC technician. One time I had a service call in which there was no power to the thermostat. The thermostat did not have power because the fuse in the air handler was blown. The fuse in the air handler was blown because there was a low voltage short. The rubber coating on one of the thermostat wires was chewed off by a rodent. The exposed metal in the thermostat wire was touching the metal cabinet of the air handler. This was a low voltage short. This low voltage...
View full post »

Similar threads

What are some best options for PCB design software?
Replies
4
Views
2K
Software to Simulate a Renewable Grid with ML
Replies
4
Views
1K
What is Baseband RF communication?
Replies
5
Views
1K
Measuring the inductance of a micron feature size gold coil
Replies
5
Views
2K
Simulation Software for a Permanent Magnet Alternator Design
Replies
7
Views
4K
Dividing the output of a VCO or....
Replies
8
Views
2K
How can I learn to use Cadence for PCB design?
Replies
4
Views
2K
Circuit Board Design: Basics of Designing a PCB
Replies
11
Views
4K
Schematic capture / wiring diagram software
Replies
18
Views
3K
What Software Can Simulate EM Wave Interactions in a Faraday Cage?
Replies
3
Views
3K

Hot Threads

Recent Insights

Back
Top