Which is More Secure: Computer Engineering or Electrical Engineering?

AI Thread Summary
The discussion centers on the comparison between pursuing Computer Engineering (CE) and Electrical Engineering (EE) in terms of job security and career prospects. Both fields offer broad applicability and share significant overlap in coursework, with CE focusing more on programming and EE on power and electronics. Concerns are raised about the job security of CE, especially during economic downturns. Participants suggest that students can start with either major and switch later if needed. Ultimately, the decision should align with personal interests and career goals.
guru
Messages
38
Reaction score
0
I noticed a similar thread has been started already, but i really want to talk about this with anyone: It's urgent. I'll need all the help I can get.
Is it better to pursue Computer Engineering (CE) or Electrical Engineering (EE)?
I learned in EE, u can do both computers and other electronics. But, what does it take to pursue EE as opposed to CE.
I'm kinda leaning towards CE. But i learned its not a very secure field; u could get out of job easily especially when the economy is bad.
I could use a lot of help from both Electrical Engineers and Computer Engineers.
Thanks
 
Engineering news on Phys.org
Neither is inherently better or worse than the other. Both have broad job applicability. The two degrees overlap significantly at most schools; the cores of the degrees are the same. Generally, computer engineers take a few extra programming classes, while electrical engineers take a few extra power or fields classes.

You can probably declare either one to start with, and switch later on if you choose.

- Warren
 
Very basic question. Consider a 3-terminal device with terminals say A,B,C. Kirchhoff Current Law (KCL) and Kirchhoff Voltage Law (KVL) establish two relationships between the 3 currents entering the terminals and the 3 terminal's voltage pairs respectively. So we have 2 equations in 6 unknowns. To proceed further we need two more (independent) equations in order to solve the circuit the 3-terminal device is connected to (basically one treats such a device as an unbalanced two-port...
suppose you have two capacitors with a 0.1 Farad value and 12 VDC rating. label these as A and B. label the terminals of each as 1 and 2. you also have a voltmeter with a 40 volt linear range for DC. you also have a 9 volt DC power supply fed by mains. you charge each capacitor to 9 volts with terminal 1 being - (negative) and terminal 2 being + (positive). you connect the voltmeter to terminal A2 and to terminal B1. does it read any voltage? can - of one capacitor discharge + of the...
Thread 'Weird near-field phenomenon I get in my EM simulation'
I recently made a basic simulation of wire antennas and I am not sure if the near field in my simulation is modeled correctly. One of the things that worry me is the fact that sometimes I see in my simulation "movements" in the near field that seems to be faster than the speed of wave propagation I defined (the speed of light in the simulation). Specifically I see "nodes" of low amplitude in the E field that are quickly "emitted" from the antenna and then slow down as they approach the far...
Back
Top