Which type of device is best for a regenerative braking system on a go cart?

  • Thread starter Thread starter siua
  • Start date Start date
  • Tags Tags
    Electric
AI Thread Summary
For a regenerative braking system on a go-kart, a motor-generator setup can effectively slow down the cart while charging the batteries. A dedicated generator designed for small-scale applications may provide better efficiency than a standard electric motor, which often struggles to perform well as a generator. It's important to consider the torque load requirements, as a golf cart motor could potentially handle the necessary force for both braking and charging. Users are encouraged to explore various manufacturers and local salvage yards for suitable components. Overall, selecting the right device is crucial for optimizing performance and energy recovery in the system.
siua
Messages
2
Reaction score
0
Hello, I am trying to design a regenerative/power system for a go cart. I know I can use a generator as a motor and vise verse, but I don't know exactly what parts to look for that will produce the best results.

I would like to use this Motor/Generator as a regenerative braking system to apply a force to slow down the cart and charge the batteries, then use the same power to start it up again to assist the motor, minus losses.

I need about 1-3 kW's.

What kind of device would be best for this application, a basic electric motor? dedicated generator like those designed for small scale wind energy? Or a specific one that is designed for both capabilities?

Any help would be appreciated. Thanks!
 
Engineering news on Phys.org
golf cart motor ?

search on that term will take you to several manufacturers

or try your local salvage yard...
 
I read a previous thread here that was saying that the electric motors don't work well as generators. Could a golf cart motor handle to torque load to slow it down and produce the needed charge?
 
Hey guys. I have a question related to electricity and alternating current. Say an alien fictional society developed electricity, and settled on a standard like 73V AC current at 46 Hz. How would appliances be designed, and what impact would the lower frequency and voltage have on transformers, wiring, TVs, computers, LEDs, motors, and heating, assuming the laws of physics and technology are the same as on Earth?
While I was rolling out a shielded cable, a though came to my mind - what happens to the current flow in the cable if there came a short between the wire and the shield in both ends of the cable? For simplicity, lets assume a 1-wire copper wire wrapped in an aluminum shield. The wire and the shield has the same cross section area. There are insulating material between them, and in both ends there is a short between them. My first thought, the total resistance of the cable would be reduced...
I used to be an HVAC technician. One time I had a service call in which there was no power to the thermostat. The thermostat did not have power because the fuse in the air handler was blown. The fuse in the air handler was blown because there was a low voltage short. The rubber coating on one of the thermostat wires was chewed off by a rodent. The exposed metal in the thermostat wire was touching the metal cabinet of the air handler. This was a low voltage short. This low voltage...
Back
Top