Why Are Commercial Jet Windows So Small?

  • Thread starter Thread starter kevinnn
  • Start date Start date
  • Tags Tags
    Airplane Windows
AI Thread Summary
Commercial jet windows are designed to be small primarily to withstand pressure differences, as smaller windows experience less force due to pressure changes. This design helps mitigate rapid decompression in case of a window breach, allowing pilots more time to descend to safer altitudes. Additionally, the structural integrity of the aircraft is enhanced by smaller windows, which reduces the risk of failure under stress. The discussion also draws parallels to construction principles, highlighting the importance of beam bending and load distribution in aircraft design. Overall, the size of jet windows is a critical safety and engineering consideration.
kevinnn
Messages
117
Reaction score
0

Homework Statement



Why are the windows on a commercial jet so small?

Homework Equations





The Attempt at a Solution


I said because the smaller the window the less force that will be applied on it due to pressure differences. But since F=AP and the pressure stays the same the larger the windows are the more force they would be susceptible to. Is this the correct answer? Thanks.
 
Physics news on Phys.org
There are more important considerations than that.
 
Yes I assumed there were. I believe another reason would be so that if a window was compromised the pressure would not drop in the airplane that fast because the air would have to escape out of a smaller area and the pilot would be able to get to lower altitudes in time. If the windows were large te pressure would change too quickly for the pilot to get to a safe altitude. Right?
 
Yes, that is a factor, too. I understand that such events have caused the loss of some planes in the past. But there is still a bigger issue. Have you ever seen a house being built?
 
Try thinking of it in terms of beam bending under a uniformly distributed load. The airplane is the analogous problem for a plate.
 
Kindly see the attached pdf. My attempt to solve it, is in it. I'm wondering if my solution is right. My idea is this: At any point of time, the ball may be assumed to be at an incline which is at an angle of θ(kindly see both the pics in the pdf file). The value of θ will continuously change and so will the value of friction. I'm not able to figure out, why my solution is wrong, if it is wrong .
TL;DR Summary: I came across this question from a Sri Lankan A-level textbook. Question - An ice cube with a length of 10 cm is immersed in water at 0 °C. An observer observes the ice cube from the water, and it seems to be 7.75 cm long. If the refractive index of water is 4/3, find the height of the ice cube immersed in the water. I could not understand how the apparent height of the ice cube in the water depends on the height of the ice cube immersed in the water. Does anyone have an...
Thread 'A bead-mass oscillatory system problem'
I can't figure out how to find the velocity of the particle at 37 degrees. Basically the bead moves with velocity towards right let's call it v1. The particle moves with some velocity v2. In frame of the bead, the particle is performing circular motion. So v of particle wrt bead would be perpendicular to the string. But how would I find the velocity of particle in ground frame? I tried using vectors to figure it out and the angle is coming out to be extremely long. One equation is by work...
Back
Top