Recent content by jayjay

i have everyting settup already but it doenst throw snow so i have to change the pulley and that's why i want to make sure i have the right pulley for the troque you'll understand better with the video there's a shaft with 2 3inch pulley that trasmit the torque but they are to small

well just trying to figure out how much force i need to the pulley to throw snow with a snowblower. that's why i found 500kg of density of snow in the snowblower cylinder that is 14 inch diameter and 5 inch deep roughly. but i might be wrong. maybe this can't be solve. also found that 1 cubic...

ok so i need to find the mass like in kg? like for an exemple a 5 gallon bucket full of snow

Hey guys What's is the formula to find the force(torque) to throw a mass in the air that is 500kg/m(3) with 2 pulley and a belt. Thanks

Great that helps me for that part thanks a lot

ok so the rpm for the pulley B will be the same for the saft if i understand

thats a picture from the internet as an example of the samething I am doing

no for myself why?

Hi guy here's an example in the picture for my project. i need to find the shaft rpm to find what size pulley D will be. Pulley B attached with a belt that come from a motor. 17.5 hp 3400 rpm 3 inch pulley if I am right and pulley b is 8.4 inch rpm 1214 torque 76 ft/lbs i think the shaft...

Wow now that's is throwing no problem with the speed your going nice job I wish I could. Figured the problem on mine I believe my issue is the 3 inch pulley on the shaft that is to small I should go. With 8 inch

Pulley that I have right now on the shaft is 3 inch from the motor and 3 inch going on both impeller pulley

Here the last test at the end the belt snap and there's no snow

TX for the reply Yes 2x27 inch together so 54 inch 8hp 10 hp moteur original 14 inch diameter also both of them same impeller and I'm guessing 1100 or 1200 rpm I don't think the belt is slipping but hoard to say if there not enough torque maybe they are

Hi Guy Hopefully someone can help me. Here's my project my issues is pulley size for getting the max torque at the impeller blower. I need to found the p2, p3 and p4 pulley size in the picture to get the maximum torque at p5 and p6. Here a link on YouTube of what I have right now it does work...