How to design a car model workin on chem. energy?

AI Thread Summary
To design a car model that operates on chemical energy, it's essential to clarify the type of chemical energy being utilized, such as combustion or battery power. Proper communication and specific questions are crucial for receiving effective assistance in project discussions. All vehicles fundamentally rely on chemical energy, which can be harnessed in various ways. Engaging with the community in a clear and structured manner will facilitate better guidance and support. Understanding these foundational concepts is key to progressing in the project.
mnz_zope
Messages
1
Reaction score
0
please help guyz its a project...
 
Engineering news on Phys.org
Welcome to PF, mnz zope.
Please use proper English in these forums. Trying to read that 'kid stuff' is very irritating.
You must post more specific questions in order to get assistance. To start with, all cars run on chemical energy of some sort, be it combustion or battery power.
 

Thread 'Bubble formation in 4 mm gap vessel'

How did you find PF?: Via Google search Hi, I have a vessel I 3D printed to investigate single bubble rise. The vessel has a 4 mm gap separated by acrylic panels. This is essentially my viewing chamber where I can record the bubble motion. The vessel is open to atmosphere. The bubble generation mechanism is composed of a syringe pump and glass capillary tube (Internal Diameter of 0.45 mm). I connect a 1/4” air line hose from the syringe to the capillary The bubble is formed at the tip...
View full post »
Thread 'Physics of Stretch: What pressure does a band apply on a cylinder?'

Thread 'Physics of Stretch: What pressure does a band apply on a cylinder?'

Scenario 1 (figure 1) A continuous loop of elastic material is stretched around two metal bars. The top bar is attached to a load cell that reads force. The lower bar can be moved downwards to stretch the elastic material. The lower bar is moved downwards until the two bars are 1190mm apart, stretching the elastic material. The bars are 5mm thick, so the total internal loop length is 1200mm (1190mm + 5mm + 5mm). At this level of stretch, the load cell reads 45N tensile force. Key numbers...
View full post »

Thread 'Find 3D Printer & Software Resources for Prototype Creation'

I'd like to create a thread with links to 3-D Printer resources, including printers and software package suggestions. My motivations are selfish, as I have a 3-D printed project that I'm working on, and I'd like to buy a simple printer and use low cost software to make the first prototype. There are some previous threads about 3-D printing like this: https://www.physicsforums.com/threads/are-3d-printers-easy-to-use-yet.917489/ but none that address the overall topic (unless I've missed...
View full post »

Similar threads

Modelling the tyre as a spring in a quarter car model (Part 2)
Replies
6
Views
1K
When are Lumped-element models used in the design process?
Replies
5
Views
1K
Resources for designing a planetary gearbox
Replies
3
Views
1K
Modelling the tyre as a spring in a quarter car model
Replies
13
Views
2K
Automotive Brake Ventilation Air Duct Design
Replies
8
Views
1K
Electric model Car design calculations help.
Replies
2
Views
2K
Automotive Calculation of energy storage system for PEV
Replies
1
Views
2K
Modeling an earthing switch for a High Voltage Impulse Generator
Replies
2
Views
1K
Design of Hydropowered Turbine Propeller for Mobile Charger
Replies
11
Views
2K
Fracture Energy for JH2 Model (Ceramics and FEA)?
Replies
2
Views
2K

Hot Threads

Recent Insights

Back
Top