Tension of rope between two blocks

AI Thread Summary
When two blocks are connected by a rope, tension acts to pull the blocks apart when they are separated, preventing the rope from expanding. If the blocks are pushed together, the rope can slack, resulting in zero tension. In this scenario, tension does not act in the opposite direction to oppose the slacking; it simply becomes non-existent. Tension is a pulling force and cannot bear compression or push objects. Understanding these properties clarifies the behavior of tension in different scenarios involving connected objects.
sweet-buds
Messages
16
Reaction score
0

Homework Statement

let's say we have 2 blocks as shown.
[]->T1----T1-<--[]

both blocks are joined by a common rope having a tension T.lets say when the blocks are pulled apart, the tension acts in the direction on the blocks as shown in figure as they try to prevent the sting from expanding. but let's say if the blocks are ppushed towards each other, the ropes would begin to slack and tension would become zero. Inthis case ,does the tension acton the blocks in the opposite direction as shown in the diagram as to oppose the slacking of rope or they simply continue to act int the same direction?if that were the case tension would begin to push the two blocks.
I am asking this bcoz I am confused with 2 properties of tension:
Tension cannot bear compression.
Tension can never push a rope or body




Homework Equations





The Attempt at a Solution

 
Physics news on Phys.org
Tension can be noted as...well...for example: the force that pulls a block when it is attached to a string. If the string slacks, then tension is 0. Another example: you take 2 blocks and have a string attached between them; if you straighten the string by pulling the blocks in opposite directions and then let go, the string will slack due to tension. At some point, it does not slack further because the tension is 0 (there is no more pull). Tension tends to pull on the object its attached to, not push.
 
Kindly see the attached pdf. My attempt to solve it, is in it. I'm wondering if my solution is right. My idea is this: At any point of time, the ball may be assumed to be at an incline which is at an angle of θ(kindly see both the pics in the pdf file). The value of θ will continuously change and so will the value of friction. I'm not able to figure out, why my solution is wrong, if it is wrong .
Thread 'Correct statement about a reservoir with an outlet pipe'
The answer to this question is statements (ii) and (iv) are correct. (i) This is FALSE because the speed of water in the tap is greater than speed at the water surface (ii) I don't even understand this statement. What does the "seal" part have to do with water flowing out? Won't the water still flow out through the tap until the tank is empty whether the reservoir is sealed or not? (iii) In my opinion, this statement would be correct. Increasing the gravitational potential energy of the...
Thread 'A bead-mass oscillatory system problem'
I can't figure out how to find the velocity of the particle at 37 degrees. Basically the bead moves with velocity towards right let's call it v1. The particle moves with some velocity v2. In frame of the bead, the particle is performing circular motion. So v of particle wrt bead would be perpendicular to the string. But how would I find the velocity of particle in ground frame? I tried using vectors to figure it out and the angle is coming out to be extremely long. One equation is by work...
Back
Top