Electric field polarization in different stations

AI Thread Summary
Electric field polarization varies among AM, FM, and TV broadcast stations, with AM stations typically using vertical polarization due to their mast or T aerials, which favor low-angle radiation. FM broadcasts in Britain historically employed horizontal polarization for aesthetic reasons and ease of installation, while modern practices often use slant or circular polarization to enhance reception for both home and portable devices. TV stations can utilize either polarization, as the shorter wavelengths minimize the impact of ground reflections, and a mix of horizontal and vertical orientations helps reduce interference. The orientation of the receiving antenna is crucial, as a vertical transmitter requires a vertical receiver, while circular polarization allows for more flexibility in antenna orientation. Understanding these polarization characteristics is essential for optimizing reception in various environments.
Gizew
Messages
1
Reaction score
0
evelam00@gmail.com how is the electric field from AM broadcast stations polarized? from TV stations? from FM broad cast stations? is there any cionnection between this polarization and orientation of receiving antenna?
 
Engineering news on Phys.org
AM stations are vertical. The aerials are usually mast radiators or T aerials. This gives low angle radiation. A hozirontal dipole would fire too much radiation at a steep angle due to ground reflections.

At VHF and UHF there is no deep technical reason why either should be used. The choice is more of convenience. It is said Horizontal can be a bit better over hilly areas and where there are a lot of trees but it may be marginal or just a theory.

TV is either. As the wavelength is so much shorter you can get transmitting aerials many wavelengths above ground and ground reflections have little effect. A mixture of hor and vert is used to reduced interference.

In Britain FM was horizontal because it was intended for home use and roof yagi aerials are easier to mount horizontally and look neater. These days slant or circular (both sometimes called 'mixed') is used to accommodate both home listeners and people in cars. It is also better for portable sets with telescopic aerials. Circular allows reception with the receiving aerial at any angle.


A vert transmitting aerial requires a vertical receiving one. Circular polarisation requires both ends to be phased in order for the electric vector to rotate in same direction but broadcasting receiving aerials tend to simple hor or vert or at at any angle.
 
Last edited:
Hey guys. I have a question related to electricity and alternating current. Say an alien fictional society developed electricity, and settled on a standard like 73V AC current at 46 Hz. How would appliances be designed, and what impact would the lower frequency and voltage have on transformers, wiring, TVs, computers, LEDs, motors, and heating, assuming the laws of physics and technology are the same as on Earth?
While I was rolling out a shielded cable, a though came to my mind - what happens to the current flow in the cable if there came a short between the wire and the shield in both ends of the cable? For simplicity, lets assume a 1-wire copper wire wrapped in an aluminum shield. The wire and the shield has the same cross section area. There are insulating material between them, and in both ends there is a short between them. My first thought, the total resistance of the cable would be reduced...
I used to be an HVAC technician. One time I had a service call in which there was no power to the thermostat. The thermostat did not have power because the fuse in the air handler was blown. The fuse in the air handler was blown because there was a low voltage short. The rubber coating on one of the thermostat wires was chewed off by a rodent. The exposed metal in the thermostat wire was touching the metal cabinet of the air handler. This was a low voltage short. This low voltage...
Back
Top