Is a 6-Position Rotary Switch the Solution for Shorting Multiple Contacts?

  • Thread starter Thread starter Liad
  • Start date Start date
  • Tags Tags
    Rotary Switch
AI Thread Summary
A 6-position rotary switch can effectively short multiple contacts by connecting each position to all previous ones. For a setup where position 3 shorts legs 1, 2, and 3, a 6-deck, 6-position switch is recommended. This configuration allows for the desired functionality of sequentially shorting contacts with each turn. Proper wiring is essential to achieve the intended results. This solution meets the requirements for a mechanical rotary switch application.
Liad
Messages
23
Reaction score
0
Hi,

I'm looking for a 6 pos, 2Amps, mechanical rotary switch that with every turn will short another contact to all of the other contacts that came before...

For example, if it's on position 3, legs 1, 2 and 3 will be shorthand all together.


Thanks.
 
Engineering news on Phys.org
Use a 6 deck, 6 position switch and wire up the way you described.
 

Thread 'Underwater piezoelectric sensor array receive sensitivity'

Hi all I have some confusion about piezoelectrical sensors combination. If i have three acoustic piezoelectrical sensors (with same receive sensitivity in dB ref V/1uPa) placed at specific distance, these sensors receive acoustic signal from a sound source placed at far field distance (Plane Wave) and from broadside. I receive output of these sensors through individual preamplifiers, add them through hardware like summer circuit adder or in software after digitization and in this way got an...
View full post »

Thread 'Following up on the recent thread about Earth Resistance measurements'

I have recently moved into a new (rather ancient) house and had a few trips of my Residual Current breaker. I dug out my old Socket tester which tell me the three pins are correct. But then the Red warning light tells me my socket(s) fail the loop test. I never had this before but my last house had an overhead supply with no Earth from the company. The tester said "get this checked" and the man said the (high but not ridiculous) earth resistance was acceptable. I stuck a new copper earth...
View full post »

Thread 'Question about bonding ground and neutral'

I am not an electrical engineering student, but a lowly apprentice electrician. I learn both on the job and also take classes for my apprenticeship. I recently wired my first transformer and I understand that the neutral and ground are bonded together in the transformer or in the service. What I don't understand is, if the neutral is a current carrying conductor, which is then bonded to the ground conductor, why does current only flow back to its source and not on the ground path...
View full post »

Similar threads

Where Can I Find a 7-Position Rotating Cylinder Switch for My Prototype Device?
Replies
7
Views
2K
How can I reroute multiple signals from a 4 pin connector using a relay switch?
Replies
37
Views
6K
Switching between parallel and series connections (solar)
Replies
31
Views
4K
High current battery switching without putting the load through the sw
Replies
3
Views
2K
High-Power Switching using MOSFETs
Replies
14
Views
4K
One of my wheelchair motors overheats and stops working
Replies
43
Views
9K
Building a rotary piston engine
Replies
2
Views
3K
Inconsistent problem about centrifugal/contact force
Replies
12
Views
3K
Novel Guitar Wiring Idea need technical advice PLEASE
Replies
10
Views
3K
Electronics Switches, Pots, Displays for DIY projects - Some ideas, some questions
Replies
6
Views
3K

Hot Threads

Recent Insights

Back
Top