Can a thermoelectric cooler be used as a thermoelectric generator?

AI Thread Summary
Thermoelectric coolers can potentially be used as thermoelectric generators, but their efficiency is significantly lower than dedicated generators. Concerns arise regarding the impact of high temperatures on the coolers, despite their ratings suggesting they can handle it. The conversion process is reversible, but the inefficiency of thermoelectric coolers means they may not produce substantial electricity. The efficiency is ultimately limited by the Carnot efficiency, which depends on the temperature difference between the hot and cold sources. Overall, while using a cooler as a generator is feasible, it is unlikely to yield efficient energy conversion.
nu_hash
Messages
10
Reaction score
0
The title should be self explanatory, the only reason I ask this is because thermoelectric coolers are ridiculously cheap compared to a thermoelectric generator.

Is there anything I need to check when using a cooler as a generator, I am expecting temperatures on the cold to be around 20C and hot around 200C. Would high temperatures damage the coolers even though are rated high enough?
 
Engineering news on Phys.org
I am afraid the energy conversion is irreversible in the thermoelectric cooler. It is like as one cannot generate electricity by cooling a freon refrigerator.
 
i believe it is reversible
but inefficient

get one and give it a try.

the thermocouple effect works both ways

but any fans or active electronics will have to be dealt with separately.
 
Thermoelectric cooler is inefficient by itself. If a reverted action is possible, according to logics, the inefficient thermoel. cooler could be turned into an efficient electricity generator ?!
 
Last edited:
...efficient electricity generator ?!

a not very efficient one i would think.

It'd be of course limited by Carnot efficiency, difference between hot and cold sources.

A google search on 'thermo electric generator efficiency' took me to several outfits selling them. They're more practical than i thought.



http://www.tegpower.com/
electrochem.org
 
Hi all I have some confusion about piezoelectrical sensors combination. If i have three acoustic piezoelectrical sensors (with same receive sensitivity in dB ref V/1uPa) placed at specific distance, these sensors receive acoustic signal from a sound source placed at far field distance (Plane Wave) and from broadside. I receive output of these sensors through individual preamplifiers, add them through hardware like summer circuit adder or in software after digitization and in this way got an...
I have recently moved into a new (rather ancient) house and had a few trips of my Residual Current breaker. I dug out my old Socket tester which tell me the three pins are correct. But then the Red warning light tells me my socket(s) fail the loop test. I never had this before but my last house had an overhead supply with no Earth from the company. The tester said "get this checked" and the man said the (high but not ridiculous) earth resistance was acceptable. I stuck a new copper earth...
I am not an electrical engineering student, but a lowly apprentice electrician. I learn both on the job and also take classes for my apprenticeship. I recently wired my first transformer and I understand that the neutral and ground are bonded together in the transformer or in the service. What I don't understand is, if the neutral is a current carrying conductor, which is then bonded to the ground conductor, why does current only flow back to its source and not on the ground path...
Back
Top