Mathematical proof for positive feedback

AI Thread Summary
Positive feedback in operational amplifiers (op-amps) can lead to saturation, which is mathematically supported by the gain equation A = A0 / (1 + βA0). In this equation, a positive feedback factor (β) reduces the denominator, causing the gain to approach infinity as β nears 1. This results in the output voltage being driven to saturation, as even minor input changes yield significant output variations. The phenomenon demonstrates that with increasing feedback, the op-amp's gain decreases and can ultimately lead to saturation. Thus, the mathematical proof confirms that positive feedback drives op-amps into saturation.
anb2020
Messages
6
Reaction score
0
Is there a mathematical proof that the positive feedback makes the op-amp saturated?

http://i.imgur.com/71PNh.png
 
Engineering news on Phys.org
Do you understand why it saturates (non-mathematical seat of the pants explanation)?
 
Let's clarify this by specifying positive DC feedback drives the opamp into saturation. Positive AC feedback makes it oscillate.
 
the_emi_guy said:
Do you understand why it saturates (non-mathematical seat of the pants explanation)?

Yes of course
 


There is indeed a mathematical proof that positive feedback can cause an operational amplifier (op-amp) to become saturated. This can be seen by analyzing the gain equation for an op-amp in a positive feedback configuration.

The gain equation for an op-amp in a closed loop configuration is given by A = A0 / (1 + βA0), where A0 is the open loop gain and β is the feedback factor. In a positive feedback configuration, the feedback factor is greater than 0, meaning that the denominator of the gain equation is less than 1.

When the feedback factor is small, the gain of the op-amp is approximately equal to the open loop gain A0. However, as the feedback factor increases, the gain decreases and eventually becomes 0 when the feedback factor is equal to 1. This means that the output voltage of the op-amp will be equal to the input voltage multiplied by the open loop gain A0, resulting in saturation.

Furthermore, the gain equation also shows that as the feedback factor approaches 1, the gain of the op-amp approaches infinity. This is known as the "infinite gain" phenomenon, where even a small change in the input voltage can cause a large change in the output voltage, leading to saturation.

In conclusion, the mathematical proof for positive feedback causing op-amp saturation lies in the gain equation, which shows that as the feedback factor increases, the gain decreases and eventually becomes 0, resulting in saturation.
 
Hi all I have some confusion about piezoelectrical sensors combination. If i have three acoustic piezoelectrical sensors (with same receive sensitivity in dB ref V/1uPa) placed at specific distance, these sensors receive acoustic signal from a sound source placed at far field distance (Plane Wave) and from broadside. I receive output of these sensors through individual preamplifiers, add them through hardware like summer circuit adder or in software after digitization and in this way got an...
I have recently moved into a new (rather ancient) house and had a few trips of my Residual Current breaker. I dug out my old Socket tester which tell me the three pins are correct. But then the Red warning light tells me my socket(s) fail the loop test. I never had this before but my last house had an overhead supply with no Earth from the company. The tester said "get this checked" and the man said the (high but not ridiculous) earth resistance was acceptable. I stuck a new copper earth...
I am not an electrical engineering student, but a lowly apprentice electrician. I learn both on the job and also take classes for my apprenticeship. I recently wired my first transformer and I understand that the neutral and ground are bonded together in the transformer or in the service. What I don't understand is, if the neutral is a current carrying conductor, which is then bonded to the ground conductor, why does current only flow back to its source and not on the ground path...

Similar threads

Replies
1
Views
2K
Replies
6
Views
3K
Replies
6
Views
2K
Replies
4
Views
1K
Replies
8
Views
3K
Replies
4
Views
2K
Replies
5
Views
2K
Back
Top