Power transformer in Maxwell 2D

AI Thread Summary
A user is seeking instruction files for designing a power transformer in Maxwell 2D and for the electrical circuit in Maxwell Circuit Editor. The forum moderator advises against sharing personal email addresses publicly to avoid spam. Participants express concern that the request may be related to homework and ask for clarification on the user's specific application. The discussion emphasizes the need for guidance on transformer design within the software. Overall, the user is looking for assistance in obtaining relevant instructional materials.
omid.tokallou
Messages
2
Reaction score
0
hi every one
I want an instruction file about design power transformer in Maxwell 2D and i want an instruction file about electrical circuit of power transformer in maxwell circuit editor
please help me
<< e-mail address deleted by Moderator -- please use PMs instead >>
please send me
thanks a lot
 
Last edited by a moderator:
Engineering news on Phys.org


omid.tokallou said:
hi every one
I want an instruction file about design power transformer in Maxwell 2D and i want an instruction file about electrical circuit of power transformer in maxwell circuit editor
please help me
<< e-mail address deleted by Moderator -- please use PMs instead >>
please send me
thanks a lot

Welcome to the PF, Omid. We discourage the posting of personal e-mail addresses in the open forums because it attracts spam bots. I've edited your e-mail address out of your post.

People can reply here in your thread, or they can send you a PM to establish e-mail contact if it is necessary for getting you the files.
 
request

hi every one
I want an instruction file about design power transformer in Maxwell 2D and i want an instruction file about electrical circuit of power transformer in maxwell circuit editor
please help me
please send me
thanks a lot
 


sounds like homework to me?
 


mack_10 said:
sounds like homework to me?

Good point.

omid.tokallou said:
hi every one
I want an instruction file about design power transformer in Maxwell 2D and i want an instruction file about electrical circuit of power transformer in maxwell circuit editor
please help me
please send me
thanks a lot

Omid, what is the application? What is it that you are trying to do?
 

Thread 'How might electronics be different if AC voltage was 72V at 45 Hz?'

Hey guys. I have a question related to electricity and alternating current. Say an alien fictional society developed electricity, and settled on a standard like 73V AC current at 46 Hz. How would appliances be designed, and what impact would the lower frequency and voltage have on transformers, wiring, TVs, computers, LEDs, motors, and heating, assuming the laws of physics and technology are the same as on Earth?
View full post »

Thread 'What happens if shielded cable has a short to the shield?'

While I was rolling out a shielded cable, a though came to my mind - what happens to the current flow in the cable if there came a short between the wire and the shield in both ends of the cable? For simplicity, lets assume a 1-wire copper wire wrapped in an aluminum shield. The wire and the shield has the same cross section area. There are insulating material between them, and in both ends there is a short between them. My first thought, the total resistance of the cable would be reduced...
View full post »

Thread 'Why does the amperage go real high if there is a low voltage short?'

I used to be an HVAC technician. One time I had a service call in which there was no power to the thermostat. The thermostat did not have power because the fuse in the air handler was blown. The fuse in the air handler was blown because there was a low voltage short. The rubber coating on one of the thermostat wires was chewed off by a rodent. The exposed metal in the thermostat wire was touching the metal cabinet of the air handler. This was a low voltage short. This low voltage...
View full post »

Similar threads

Maxwell Ansoft and Circuit Editor
Replies
1
Views
3K
Open circuit test of 3 phase transformer in Ansys Maxwell
Replies
4
Views
5K
Ansys Maxwell Modeling of Switched Reluctance Motors
Replies
4
Views
3K
"Ground" and "Center Tapped" Power Transformer Secondary in guitar amp
Replies
6
Views
4K
Help with building this transformer in ltspice
Replies
21
Views
4K
How simulate a transformer with Maxwell Ansoft?
Replies
44
Views
26K
Transformer without separate primary and secondary windings....
Replies
14
Views
3K
How to incorporate core losses in an ANSOFT 2D transformer model
Replies
4
Views
3K
Designing Your Own Transformer for Electrical Engineers
Replies
13
Views
3K
Why Isn't My Coil Simulation Achieving the Expected 8pT Signal in Maxwell?
Replies
1
Views
2K

Hot Threads

Recent Insights

Back
Top