How can Kirchhoff's Laws be used to find node voltage in a circuit?

AI Thread Summary
Kirchhoff's Laws are essential for analyzing circuits, particularly for finding node voltages. Users are encouraged to apply Kirchhoff's Current Law (KCL) and Kirchhoff's Voltage Law (KVL) to their circuit schematics for accurate results. Providing a schematic along with attempted calculations can help others offer targeted assistance. Common issues with voltage discrepancies may arise from incorrect application of these laws. Engaging with the community by sharing specific circuit details can lead to effective troubleshooting and solutions.
jtn7040
Messages
1
Reaction score
0
Hi.. I'm trying to figure out how to find voltage over nodes in a circuit can anyone give me a crash course or just explain it... I've been using KCL to find it but my voltages are always out of whack... any suggestions would be helpful
 
Engineering news on Phys.org
Show a schematic and your attempt to solve it, and we can help you.
 
Read about Kirkoff's Laws and apply them in your circuit. Otherwise, post a schematic and we may find an easier way to solve it.
 

Thread 'Underwater piezoelectric sensor array receive sensitivity'

Hi all I have some confusion about piezoelectrical sensors combination. If i have three acoustic piezoelectrical sensors (with same receive sensitivity in dB ref V/1uPa) placed at specific distance, these sensors receive acoustic signal from a sound source placed at far field distance (Plane Wave) and from broadside. I receive output of these sensors through individual preamplifiers, add them through hardware like summer circuit adder or in software after digitization and in this way got an...
View full post »

Thread 'Following up on the recent thread about Earth Resistance measurements'

I have recently moved into a new (rather ancient) house and had a few trips of my Residual Current breaker. I dug out my old Socket tester which tell me the three pins are correct. But then the Red warning light tells me my socket(s) fail the loop test. I never had this before but my last house had an overhead supply with no Earth from the company. The tester said "get this checked" and the man said the (high but not ridiculous) earth resistance was acceptable. I stuck a new copper earth...
View full post »

Thread 'Question about bonding ground and neutral'

I am not an electrical engineering student, but a lowly apprentice electrician. I learn both on the job and also take classes for my apprenticeship. I recently wired my first transformer and I understand that the neutral and ground are bonded together in the transformer or in the service. What I don't understand is, if the neutral is a current carrying conductor, which is then bonded to the ground conductor, why does current only flow back to its source and not on the ground path...
View full post »

Similar threads

How is KVL used in the node method KCL equations?
Replies
3
Views
2K
How to figure the voltage drop at different points along a circuit?
Replies
38
Views
6K
How to enhance output Voltages of this RF Power Amplifier
Replies
16
Views
2K
DC input random offset voltage for diff. amplifier with current-mirror load
Replies
2
Views
1K
Explaining Voltage Split in Series Circuits with Ohm's Law
Replies
6
Views
2K
Find Voltage at Node 1 in Op-amp CMRR Circuit
Replies
10
Views
2K
Engineering Why is the voltage source high potential into node 1 at -12 V in this op amp problem?
Replies
15
Views
2K
Nodal analysis, choosing number of nodes confusion
Replies
1
Views
3K
Solve for phase-to-neutral voltage in terms of phase-to-phase voltage
Replies
14
Views
5K
Engineering How do I find Vth with the node voltage method?
Replies
10
Views
3K

Hot Threads

Recent Insights

Back
Top