Basic STAMP 2 Microcontroller: Good Choice for a Stepper Motor Project?

AI Thread Summary
The Basic STAMP 2 microcontroller is being considered for a project involving stepper motors to automatically point an antenna for optimal signal reception. There is limited information available about the STAMP 2, raising questions about its suitability for this application. Participants are seeking recommendations for resources or books to learn more about the microcontroller. Alternatives to the STAMP 2 are also being explored for the same project. Overall, the discussion emphasizes the need for more information and guidance on using the Basic STAMP 2 effectively.
paul11273
Messages
155
Reaction score
0
Is anyone familiar with the Basic STAMP 2 microcontoller?
I have found a little information about it, but not much. I would like to start tinkering around with some type of microcontroller, probably something to run stepper motors. Would this be a good choice?

Specifically, I am thinking about a project that would automatically point an antenna toward the source of a signal for optimal reception. Would the STAMP micro be a good choice? What would be some good books / resources to learn about it?

If not, what alternatives are out there for this application?

Thanks.
 
Engineering news on Phys.org

Thread 'Underwater piezoelectric sensor array receive sensitivity'

Hi all I have some confusion about piezoelectrical sensors combination. If i have three acoustic piezoelectrical sensors (with same receive sensitivity in dB ref V/1uPa) placed at specific distance, these sensors receive acoustic signal from a sound source placed at far field distance (Plane Wave) and from broadside. I receive output of these sensors through individual preamplifiers, add them through hardware like summer circuit adder or in software after digitization and in this way got an...
View full post »

Thread 'Question about bonding ground and neutral'

I am not an electrical engineering student, but a lowly apprentice electrician. I learn both on the job and also take classes for my apprenticeship. I recently wired my first transformer and I understand that the neutral and ground are bonded together in the transformer or in the service. What I don't understand is, if the neutral is a current carrying conductor, which is then bonded to the ground conductor, why does current only flow back to its source and not on the ground path...
View full post »

Thread 'Following up on the recent thread about Earth Resistance measurements'

I have recently moved into a new (rather ancient) house and had a few trips of my Residual Current breaker. I dug out my old Socket tester which tell me the three pins are correct. But then the Red warning light tells me my socket(s) fail the loop test. I never had this before but my last house had an overhead supply with no Earth from the company. The tester said "get this checked" and the man said the (high but not ridiculous) earth resistance was acceptable. I stuck a new copper earth...
View full post »

Similar threads

Silent DC Motor for Automatic Watch Winder | Feasibility Study Stage
Replies
17
Views
2K
Need help with my project -- microcontroller for DC motor controller
Replies
3
Views
2K
Dividing the output of a VCO or....
Replies
8
Views
2K
Choice of motors, please advise
Replies
7
Views
2K
Microcontroller kit beyond beginner
Replies
5
Views
3K
Which microcontroller is recommended for a home automated system project?
Replies
9
Views
4K
How Can I Control a Stepper Motor with LabView?
Replies
7
Views
3K
Crystal Radios and Followups
Replies
37
Views
4K
Microcontroller kit for a beginner embedded systems hobbyist
Replies
4
Views
4K
How can I make my wheel motor electromagnets stronger for a high school project?
Replies
2
Views
3K

Hot Threads

Recent Insights

Back
Top