Finding direction of a source using directional antenna?

AI Thread Summary
Using four directional antennas to locate the direction of a source in four quadrants is a viable method for detecting electromagnetic waves. This technique has historical significance, particularly in military applications for locating radio emissions. Current systems can provide immediate source bearings, although the specific methods may vary. Research on passive radio direction finding has been extensive, with numerous resources available for further exploration. Overall, the approach of using multiple antennas remains a well-established practice in the field.
guns
Messages
4
Reaction score
0
Hi all,

Is it possible to find the direction of a source in 4 quadrants using directional antenna?
I am thinking of setting up 4 directional antennas, facing to 4 quadrants, and they will receive the waves from the according quadrants.
What do you guys think about this? And is there any easier way to find the direction of a source by receiving its EM wave? thanks.
 
Engineering news on Phys.org
Afaik, this is a well established procedure and was an area of considerable research by the military, who have an obvious interest in locating the sources of radio emissions. Current day systems offer source bearings immediately as a matter of course, but I do not know the specific technique involved.
 
For around one hundred years folks have been detecting the direction of the source of radio signals. During a Google search using the terms “passive radio direction finding” I found this excellent history with examples within approximately twelve seconds:

“Radio Direction Finding”
http://www.astrosol.ch/thisandthat/5379039a840e79e07/

This is only one of many more available to the searcher, if only the search effort is expended.
Bobbywhy
 
Last edited by a moderator:
Hey guys. I have a question related to electricity and alternating current. Say an alien fictional society developed electricity, and settled on a standard like 73V AC current at 46 Hz. How would appliances be designed, and what impact would the lower frequency and voltage have on transformers, wiring, TVs, computers, LEDs, motors, and heating, assuming the laws of physics and technology are the same as on Earth?
While I was rolling out a shielded cable, a though came to my mind - what happens to the current flow in the cable if there came a short between the wire and the shield in both ends of the cable? For simplicity, lets assume a 1-wire copper wire wrapped in an aluminum shield. The wire and the shield has the same cross section area. There are insulating material between them, and in both ends there is a short between them. My first thought, the total resistance of the cable would be reduced...
I used to be an HVAC technician. One time I had a service call in which there was no power to the thermostat. The thermostat did not have power because the fuse in the air handler was blown. The fuse in the air handler was blown because there was a low voltage short. The rubber coating on one of the thermostat wires was chewed off by a rodent. The exposed metal in the thermostat wire was touching the metal cabinet of the air handler. This was a low voltage short. This low voltage...
Back
Top